On Saturday 15 January 2005 10:59, Tony Boom wrote: > I've almost given up on getting it to work.
Not sure if this will help pinpoint my problem, the output from dmsg: It's all Klingon to me. bttv: driver version 0.9.15 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11 ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI 11 (level, low) -> IRQ 11 bttv0: Bt878 (rev 2) at 0000:00:0a.0, irq: 11, latency: 32, mmio: 0xe4115000 bttv0: detected: Hauppauge WinTV [card=10], PCI subsystem ID is 0070:13eb bttv0: using: Hauppauge (bt878) [card=10,autodetected] bttv0: gpio: en=00000000, out=00000000 in=00ffffdb [init] bttv0: Hauppauge/Voodoo msp34xx: reset line init [5] bttv0: Hauppauge eeprom: model=61314, tuner=Philips FI1216 MK2 (5), radio=no bttv0: using tuner=5 bttv0: i2c: checking for MSP34xx @ 0x80... found msp34xx: init: chip=MSP3410D-B4 +nicam +simple mode=simple msp3410: daemon started bttv0: i2c: checking for TDA9875 @ 0xb0... not found bttv0: i2c: checking for TDA7432 @ 0x8a... not found tvaudio: TV audio decoder + audio/video mux driver tvaudio: known chips: tda9840,tda9873h,tda9874h/a,tda9850,tda9855,tea6300,tea6420,tda8425,pic16c54 (PV951),ta8874z bttv0: i2c: checking for TDA9887 @ 0x86... not found tuner: chip found at addr 0xc2 i2c-bus bt878 #0 [sw] tuner: type set to 5 (Philips PAL_BG (FI1216 and compatibles)) by bt878 #0 [sw] bttv0: registered device video0 bttv0: registered device vbi0 bttv0: PLL: 28636363 => 35468950 .. ok -- Tony. Gentoo Linux. Registered Linux user #316959 -- [email protected] mailing list
