Hi,
I got some problems with my Broadcom 4311 wireless card.
It's a DELL Inspiron E1505.
I can't setup the wireless with WPA/TKIP
Here are my config files and the output of wpa_supplicant with debug info.
denver ~ # cat /etc/conf.d/net
# This blank configuration will automatically use DHCP for any net.*
# scripts in /etc/init.d. To create a more complete configuration,
# please review /etc/conf.d/net.example and save your configuration
# in /etc/conf.d/net (this file :]!).
# Prefer wpa_supplicant over wireless-tools
modules=( "wpa_supplicant" )
#modules=( "iwconfig" )
# It's important that we tell wpa_supplicant which driver we should
# be using as it's not very good at guessing yet
wpa_supplicant_eth1="-Dwext"
dhcpcd_eth0="-t 90"
------------------------------------------------------------------------------------------------------------
denver ~ # cat /etc/wpa_supplicant/wpa_supplicant.conf
# This is a network block that connects to any unsecured access point.
# We give it a low priority so any defined blocks are preferred.
#network={
# key_mgmt=NONE
# priority=-9999999
#}
network={
ssid="APT22B"
key_mgmt=WPA-PSK
psk="Jr*pes2f"
priority=5
proto=WPA
pairwise=CCMP TKIP
group=CCMP TKIP
scan_ssid=1
}
-----------------------------------------------------------------------------------------------------------------------
denver ~ # wpa_supplicant -Dwext -ieth1 -c
/etc/wpa_supplicant/wpa_supplicant.conf -dd
Initializing interface 'eth1' conf '/etc/wpa_supplicant/wpa_supplicant.conf'
driver 'wext' ctrl_interface 'N/A' bridge 'N/A'
Configuration file '/etc/wpa_supplicant/wpa_supplicant.conf' ->
'/etc/wpa_supplicant/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant/wpa_supplicant.conf'
Line: 8 - start of a new network block
ssid - hexdump_ascii(len=6):
41 50 54 32 32 42 APT22B
key_mgmt: 0x2
PSK (ASCII passphrase) - hexdump_ascii(len=8): [REMOVED]
priority=5 (0x5)
proto: 0x1
pairwise: 0x18
group: 0x18
scan_ssid=1 (0x1)
PSK (from passphrase) - hexdump(len=32): [REMOVED]
Priority group 5
id=0 ssid='APT22B'
Initializing interface (2) 'eth1'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
SIOCGIWRANGE: WE(compiled)=21 WE(source)=18 enc_capa=0xf
capabilities: key_mgmt 0xf enc 0xf
WEXT: Operstate: linkmode=1, operstate=5
Own MAC address: 00:1b:fc:68:7b:a7
wpa_driver_wext_set_wpa
wpa_driver_wext_set_key: alg=0 key_idx=0 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=1 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=2 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_key: alg=0 key_idx=3 set_tx=0 seq_len=0 key_len=0
wpa_driver_wext_set_countermeasures
wpa_driver_wext_set_drop_unencrypted
Setting scan request: 0 sec 100000 usec
Added interface eth1
RTM_NEWLINK: operstate=0 ifi_flags=0x1002 ()
Wireless event: cmd=0x8b06 len=12
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
RTM_NEWLINK: operstate=0 ifi_flags=0x1003 ([UP])
RTM_NEWLINK, IFLA_IFNAME: Interface 'eth1' added
State: DISCONNECTED -> SCANNING
Starting AP scan (specific SSID)
Scan SSID - hexdump_ascii(len=6):
41 50 54 32 32 42 APT22B
Trying to get current scan results first without requesting a new scan to
speed up initial association
ioctl[SIOCGIWSCAN]: Resource temporarily unavailable
Scan results: -1
Failed to get scan results
Failed to get scan results - try scanning again
Setting scan request: 0 sec 0 usec
Starting AP scan (broadcast SSID)
Scan timeout - try to get results
ioctl[SIOCGIWSCAN]: Resource temporarily unavailable
Scan results: -1
Failed to get scan results
Failed to get scan results - try scanning again
Setting scan request: 1 sec 0 usec
Starting AP scan (specific SSID)
Scan SSID - hexdump_ascii(len=6):
41 50 54 32 32 42 APT22B
Scan timeout - try to get results
ioctl[SIOCGIWSCAN]: Resource temporarily unavailable
Scan results: -1
Failed to get scan results
Failed to get scan results - try scanning again
Setting scan request: 1 sec 0 usec
Starting AP scan (broadcast SSID)
Scan timeout - try to get results
ioctl[SIOCGIWSCAN]: Resource temporarily unavailable
Scan results: -1
Failed to get scan results
Failed to get scan results - try scanning again
Setting scan request: 1 sec 0 usec
Starting AP scan (specific SSID)
Scan SSID - hexdump_ascii(len=6):
41 50 54 32 32 42 APT22B
CTRL-EVENT-TERMINATING - signal 2 received
Removing interface eth1
State: SCANNING -> DISCONNECTED
wpa_driver_wext_set_operstate: operstate 0->0 (DORMANT)
WEXT: Operstate: linkmode=-1, operstate=5
No keys have been configured - skip key clearing
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
wpa_driver_wext_set_wpa
wpa_driver_wext_set_drop_unencrypted
wpa_driver_wext_set_countermeasures
No keys have been configured - skip key clearing
Cancelling scan request
Cancelling authentication timeout
WEXT: Operstate: linkmode=0, operstate=6
denver ~ #
