The following lines worries me a bit. On Mon, Aug 27, 2007 at 12:16:23AM -0400, Penguin Lover Lingyun Yang squawked: > Starting AP scan (specific SSID) > Scan SSID - hexdump_ascii(len=6): > 41 50 54 32 32 42 APT22B > Trying to get current scan results first without requesting a new scan to > speed up initial association > ioctl[SIOCGIWSCAN]: Resource temporarily unavailable > Scan results: -1 > Failed to get scan results > Failed to get scan results - try scanning again > Setting scan request: 0 sec 0 usec > Starting AP scan (broadcast SSID) > Scan timeout - try to get results > ioctl[SIOCGIWSCAN]: Resource temporarily unavailable > Scan results: -1 > Failed to get scan results > Failed to get scan results - try scanning again
The resource temporarily unavailable error is probably not good. Two things you can try: 1) Can you even scan the network (without using wpa_supplicant). If you have wireless-tools installed (you should), after loading the kernel module, try running 'iwlist eth1 scan', does it produce a nice list of the cells in your area? 2) Is this a WPA problem or a problem on hardware/driver? Can you connect to other types of networks? Unencrypted? WEP? Dmesg output in regards to the bcm43xx driver and possibly softmac would also be useful. How did you install the 4311 drivers? Try following the directions here? http://forums.gentoo.org/viewtopic-t-409194-postdays-0-postorder-asc-start-0.html Best of luck, W -- Cross Product is an Abomination. ~Prof. Edward Nelson. MAT 217. P-Town Sortir en Pantoufles: up 262 days, 14:04 -- [EMAIL PROTECTED] mailing list
