Yes,
I have already  rebuild all my drivers through "revdep-rebuild".
More over i am not able to find any eth1/wlan0  interface.
---------------------------------------------------------------------------------------------
flukebox flukebox # ifconfig
eth0      Link encap:Ethernet  HWaddr 00:19:B9:80:97:66
          inet addr:172.24.0.234  Bcast:172.24.7.255  Mask:255.255.248.0
          inet6 addr: fe80::219:b9ff:fe80:9766/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:403919 errors:0 dropped:0 overruns:0 frame:0
          TX packets:66919 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:156546805 (149.2 Mb)  TX bytes:6978869 (6.6 Mb)
          Interrupt:16

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:759 errors:0 dropped:0 overruns:0 frame:0
          TX packets:759 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:833199 (813.6 Kb)  TX bytes:833199 (813.6 Kb)

flukebox flukebox # iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

sit0      no wireless extensions.

ip6tnl0   no wireless extensions.

flukebox flukebox #
--------------------------------------------------------------------------------------------

thanks,
flukebox





On Feb 9, 2008 5:02 PM, Ian Lee <[EMAIL PROTECTED]> wrote:

> dell core2duo wrote:
> > Hi all,
> >    I was using kernel 2.6.23 till now and everything was working
> > pretty well.
> >  My wireless card is ---0c:00.0 Network controller: Broadcom
> > Corporation BCM94311MCG wlan mini-PCI (rev 01).
> > It was working fine with kernel 2.6.23 with ndiswrapper. Yesterday i
> > upgraded to kernel 2.4.26. And my wireless card
> > stopped working.  It says that eth1 does not exist.
> > Some important out are below
> >
> -------------------------------------------------------------------------------------------------------
> > flukebox # ndiswrapper -l
> > bcmwl5 : driver installed
> >     device (14E4:4311) present
> > flukebox # /etc/init.d/net.eth1 start
> >  * Starting eth1
> >  *     /etc/conf.d/wireless is deprecated
> >  *     Please put all settings in /etc/conf.d/net
> >  *     /etc/conf.d/wireless is deprecated
> >  *     Please put all settings in /etc/conf.d/net
> >  *   Configuration not set for eth1 - assuming DHCP
> >  *   Bringing up eth1
> >  *     dhcp
> >  *       network interface eth1 does not exist
> >  *       Please verify hardware or kernel module
> > (driver)
> > [ !! ]
> > flukebox #
> >
> --------------------------------------------------------------------------------------------------------
> >
> > I didn't have any kernel built-in module for bcmxx .
> > Can somebody help me here. Any help would be appreciated.
> >
> > TIA,
> > flukebox
> >
> >
> >
> >
> >
> Have u rebuilt the ndiswprapper kernel module for the new kernel?
> try reinstalling ndiswrapper
> --
> [email protected] mailing list
>
>

Reply via email to