You can do the same in montaj and back to decimal degree by clicking normal from drop drown. Best wishes Mohammednur
On Tuesday, February 25, 2014 3:25 PM, Darren Andrews <[email protected]> wrote: Hi Mwape, In Target you can do the following: 1. Right-click on the longitude or latitude channel header cell and select edit. 2. The Edit Channel dialog will open. You will probably see that the Display format within is “Hexidecimal” (i.e. decimal degrees). 3. Change the Display format to “Geographic”, your data will then be converted to degrees minutes seconds. Best regards, Darren Andrews -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of mwape_somanje Sent: Tuesday, 25 February 2014 9:32 AM To: Geosoft Oasis montaj and Target Subject: [geonet] Converting Coordinates from DD to DMS Dear All Does anyone know the easiest way of converting the lot of coordinates from = decimal degrees to degrees minutes seconds. I have tried via ArcMap can't f= ind a way through, anyone know if it can be done in target? Regards Mwape --- Forum archives can be accessed here: http://lyris.geosoft.com/read/?fourm=geonet You are currently subscribed to geonet as: [email protected]. To subscribe or unsubscribe from any of our forums, select the User Forum selection on the Geosoft Community page: http://www.geosoft.com/support/community --- Forum archives can be accessed here: http://lyris.geosoft.com/read/?fourm=geonet You are currently subscribed to geonet as: [email protected]. To subscribe or unsubscribe from any of our forums, select the User Forum selection on the Geosoft Community page: http://www.geosoft.com/support/community --- Forum archives can be accessed here: http://lyris.geosoft.com/read/?fourm=geonet You are currently subscribed to geonet as: [email protected]. To subscribe or unsubscribe from any of our forums, select the User Forum selection on the Geosoft Community page: http://www.geosoft.com/support/community
