Mwape
There is a great little program called Geographic Tool on a site called New
Binary Earth. The program that will allow you to run a file of more than 4
points will cost you all of $4 but you can run up to 4 points on a freebie.
The good part is that when you click on the Google Earth link it takes you
directly to the point in Google Earth. Not bad for a free program and great
when you are away from your computer and your Geosoft licence. I have
checked it against the Geosoft calculated values and it is fine.
Regards
Keith
----- Original Message -----
From: "mwape_somanje" <[email protected]>
To: "Geosoft Oasis montaj and Target" <[email protected]>
Sent: Tuesday, February 25, 2014 10:31 PM
Subject: [geonet] Converting Coordinates from DD to DMS
Dear All
Does anyone know the easiest way of converting the lot of coordinates from
= decimal degrees to degrees minutes seconds. I have tried via ArcMap
can't f= ind a way through, anyone know if it can be done in target?
Regards
Mwape
---
Forum archives can be accessed here:
http://lyris.geosoft.com/read/?fourm=geonet
You are currently subscribed to geonet as: [email protected].
To subscribe or unsubscribe from any of our forums, select the User Forum
selection on the Geosoft Community page:
http://www.geosoft.com/support/community
---
Forum archives can be accessed here: http://lyris.geosoft.com/read/?fourm=geonet
You are currently subscribed to geonet as: [email protected].
To subscribe or unsubscribe from any of our forums, select the User Forum
selection on the Geosoft Community page:
http://www.geosoft.com/support/community
