----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Which type of gauge? Header tank? Built-in wing tank? Vertical tube type, or dial indicator? Greg At 10:39 AM 7/31/02 -0700, Fly Bum wrote: >----[Please read http://ercoupers.com/disclaimer.htm before following any >advice in this forum.]---- > > >The float on my Coupe is made of brass. Just a little >cylinder with the wire brazed to the top. It's >leaking and looks pretty beat up and needs to be >replaced. Just called Univair and they don't supply >floats for liability reasons (say auto fuel eats the >shellac coatings on the cork ones). Do any of you >know if the brass ones were a legal replacement and if >so where to get one (Univair didn't know and Lee is >not at work at Skyport yet)? > >Also, if I have to go with a cork one how do you keep >the cork from sliding off the bottom? The top is held >with a small washer that is silver soldered to the >wire but I imagine trying to silver solder a washer to >the bottom with the cork on the wire would burn the >cork too badly. Or maybe they sell an assembly with >the cork already on the wire? > >Thanks. > >Joa > >__________________________________________________ >Do You Yahoo!? >Yahoo! Health - Feel better, live better >http://health.yahoo.com >================================================================== >TO UNSUBSCRIBE go to: http://ercoupers.com/lists.htm > ================================================================== TO UNSUBSCRIBE go to: http://ercoupers.com/lists.htm
<<attachment: winmail.dat>>
