Your model seems to have only lines and points, that's why you don't see
a 2D/3D mesh.
The 1D mesh is done correctly.
Ruth
Roland Tollenaar wrote:
Hello,
I have a model which fails to mesh. gmsh says its meshing it (console)
but nothing happens. (0s)
I have seen this same behaviour with STL models previously and simply
assumed that gmsh could not handle stl files.
However this is a step model of a type that gmsh previously did mesh
well.
I have attached the model.
Kind regards,
Roland
------------------------------------------------------------------------
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
--
Dr. Ir. Ruth V. Sabariego
University of Liege, Institut Montefiore,
Dept. of Electrical Engineering & Computer Science,
Applied & Computational Electromagnetics (ACE),
Sart Tilman Campus, Grande Traverse, 10 (B28), B-4000 LIEGE, Belgium
phone: +32-4-3663737 -- fax: +32-4-3662910 -- http://elap.montefiore.ulg.ac.be/
_______________________________________________
gmsh mailing list
[email protected]
http://www.geuz.org/mailman/listinfo/gmsh
