> On 4 Dec 2017, at 10:59, Jeremy Theler <[email protected]> wrote: > > Is the new property Geometry.OCCTargetUnit working as expected? >
Yes. > How can I revert back to the original behavior, i.e. do not assume anything > about units in an imported OCC model and leave them as "non-dimensional"? Actually, when importing a STEP and IGES file with OpenCASCADE a "target unit" was always set - and it was set to "MM", i.e. millimeters. To revert millimeters, use Geometry.OCCTargetUnit = "MM"; Christophe > > Thanks > -- > Jeremy Theler > www.seamplex.com > > _______________________________________________ > gmsh mailing list > [email protected] > http://onelab.info/mailman/listinfo/gmsh -- Prof. Christophe Geuzaine University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine Free software: http://gmsh.info | http://getdp.info | http://onelab.info _______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
