Hi Chrstophe I tried setting it to "MM" and the result was the same. I will take a look again and send a mwe illustrating the issue.
Regards jeremy On Mon, Dec 4, 2017, 08:45 Christophe Geuzaine <[email protected]> wrote: > > > > On 4 Dec 2017, at 10:59, Jeremy Theler <[email protected]> wrote: > > > > Is the new property Geometry.OCCTargetUnit working as expected? > > > > Yes. > > > How can I revert back to the original behavior, i.e. do not assume > anything about units in an imported OCC model and leave them as > "non-dimensional"? > > Actually, when importing a STEP and IGES file with OpenCASCADE a "target > unit" was always set - and it was set to "MM", i.e. millimeters. > > To revert millimeters, use Geometry.OCCTargetUnit = "MM"; > > Christophe > > > > > Thanks > > -- > > Jeremy Theler > > www.seamplex.com > > > > _______________________________________________ > > gmsh mailing list > > [email protected] > > http://onelab.info/mailman/listinfo/gmsh > > > -- > Prof. Christophe Geuzaine > University of Liege, Electrical Engineering and Computer Science > http://www.montefiore.ulg.ac.be/~geuzaine > > Free software: http://gmsh.info | http://getdp.info | http://onelab.info > > -- -- jeremy theler www.seamplex.com
_______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
