Dear all,
I am trying to use gmsh to mesh with hexaedra two volumes separated by a
smooth non-flat interface. The entire volume is a cube.
After many tries, I identified a meshing strategy but the results is not
good enough.
Is there a preferred strategy for the choice of a 2D and 3D algorithms
to achieve this objective ?
I faced many crashes depending on the options I chose.
I was able to obtain very good 2D meshes but when trying to get a 3D
mesh the result is not good.
Thank you
Paul
--
*--------------------------------------------------------------------------*
Paul CRISTINI Charge de Recherche CNRS (HDR) / CNRS Research Scientist
*--------------------------------------------------------------------------*
CNRS - Laboratoire de Mecanique et d'Acoustique (UMR 7031)
Bureau 119
4 Impasse Nikola Tesla, CS 40006, F-13453 Marseille Cedex 13 - France
mailto: crist...@lma.cnrs-mrs.fr
phone number: +33 (0)4 84 52 42 51
http://www.lma.cnrs-mrs.fr/
*--------------------------------------------------------------------------*
_______________________________________________
gmsh mailing list
gmsh@onelab.info
http://onelab.info/mailman/listinfo/gmsh
