Dear Michel, Does this happens with the latest version? If it does, could you share a minimal example when we could reproduce the problem?
Thanks, Christophe > On 14 Mar 2019, at 22:53, Michel Cassagnes <[email protected]> wrote: > > Dear all, > > I am using mesh with Delaunay for quads and then Recombine to get quads (and > some triangles, I don't need only quads). Resulting mesh seems very good but > when I use it for calculations, it appears that the mesh contains some quads > with two edges aligned so unusable and that leads to errors. > > What can be done to correct this issue ? Is there a parameter to control > angles in resulting quads that could allow keeping triangle instead if it > occurs? > > Best regards, > > Michel Cassagnes > _______________________________________________ > gmsh mailing list > [email protected] > http://onelab.info/mailman/listinfo/gmsh — Prof. Christophe Geuzaine University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine _______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
