> On 5 Jul 2019, at 15:17, Alessandro Vicini <[email protected]> > wrote: > > > Sorry if in these days I’m spamming a bit… J > > I attach a geo file (Test_04, together with spline.geo which is merged into > it). I need to generate the plane surface which is shown in the attached > picture, but gmsh doesn’t accept the inner circle as a hole…. Any > suggestions…? Thank you. >
Hi Alessandro, I don't get the same geometry as yours when I open your file with Gmsh 4.4. Can you check? Christophe > Alessandro > > <Test_04.geo><spline.geo><surface.jpg>_______________________________________________ > gmsh mailing list > [email protected] > http://onelab.info/mailman/listinfo/gmsh — Prof. Christophe Geuzaine University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine _______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
