> On 3 Nov 2019, at 13:34, Mahesh Prasad <[email protected]> > wrote: > > Hi gmsh community, > > I am trying to mesh my 3D geometry that contains multiple volumes. Each > volume is defined individually in the (.geo) file and the volumes match along > the intersecting surfaces. > Now when I try to mesh this, only the volumes that lie completely inside the > geometry gets meshed. I have attached my (.geo) file in which 54 volumes are > defined, and only 19 volumes undergo 3D meshing. Could some point to what > mistake I am making ?
Volumes should be simply connected. Volume 4 for example contains two non-connected parts. Christophe > > NOTE: After importing this geometry into gmsh, I use "Coherence" to remove > duplicate points lines and surfaces. > > Thank you all in advance. > > Best Regards > Mahesh<test_vol.geo>_______________________________________________ > gmsh mailing list > [email protected] > http://onelab.info/mailman/listinfo/gmsh — Prof. Christophe Geuzaine University of Liege, Electrical Engineering and Computer Science http://www.montefiore.ulg.ac.be/~geuzaine _______________________________________________ gmsh mailing list [email protected] http://onelab.info/mailman/listinfo/gmsh
