Dear all,
from a STL surface I meshed a volume. I need to have one surface to
apply a pressure boundary condition in a subsequent Abaqus analysis. The
problem of keeping the surface and the volume is that elements and nodes
are duplicated (even if I tried coherence / remove duplicate options).
Is there a way of defining a *Surface set (defined in abaqus by the
facet of the elements on where to apply the BC). From what I've read,
I'm not sure if this is possible.
Best,
MA
_______________________________________________
gmsh mailing list
[email protected]
http://onelab.info/mailman/listinfo/gmsh
