i have all the sensors including the one that goes at the front of the radiator support for outside temperature. but still no work.
i ripped out all the pieces from the front of the car including the fuses/replys that the outdoor sensor goes towards. on a non climate control setup with aircon, there is a six pin plug and only 4 are in use, where as the climate control has six in use, due to the 2 extra wires that goes towards the outside temp sensor. This plug is near the fire wall next to where the aircon pipes hook up at the firewall. There is a few sensors, there is 1) a sensor that goes inside the splitter box 2) a sensor on the top of the dash 3) a sensor that goes inside the aircon box 4) a sensor that goes outside for outside temp (on radiator support) 5) and a apparently the condune type of tube that goes at the back of the climate control unit measures inside temp (i think) i have all of these, i have the complete setup, all i need to know is how to hook up the outside temp to work, and if anyone has a spare servo that hooks on to the blower box, it would be greatly appreciated. --- In [email protected], Allan Oliveira <[EMAIL PROTECTED]> wrote: > > Nah, stock CC is all manual wires. > > For the outside temp to work you should have a sensor that ends up all > the way out the front of the car (I think, I was never 100% about this > sensor, was black and looked like a smooth capsule about 5 cm long). The > only other sensor was an IR type one which sat right in the middle of > the dash pointing up into the sky. I assumed this was the inside sensor > but might be the outside one and the inside one is in one of the boxes? > > I still think the outside capsule thingo was more likely to be the out > side sensor though... > > Al > > Stan the man wrote: > > > > > > oh its a servo, not the actual blower motor, no i dont think the stock > > CC box comes with it, from memmory. > > > > Hmm could just check the black wire if its ground. Does the servo motor > > work? Or thats the stuffed part, normally motors are pretty tough, could > > just take it apart if possible and check if all ok (grease up the monkey). > > > > Ill have a look see if i can find what wires go into the box. > > > > ------------------------------------------------------------- ----------- > > From: /"boost_lover" <[EMAIL PROTECTED]>/ > > Reply-To: /[email protected]/ > > To: /[email protected]/ > > Subject: /[GSR_EVO] Re: climate control help extra/ > > Date: /Mon, 07 Aug 2006 06:19:45 -0000/ > > > > there is three boxes, the blower box (left), the aircon box (middle) > > and the splitter box (right) > > > > the servo i am having problems with is the blower box. The servo > > controls where the air comes from either inside or outside. That is > > stuffed on my setup. Is that of any help to direct you to the right > > servo? > > > > There is two wires from the outside temp sensor, and i have located > > one wire at the back of the unit, but the second wire i have no idea. > > > > The wire that i have located is yellow with a blue stripe, but the > > problem where there is a difference, the other wire at the sensor is > > black with a blue stripe, where as there is no spare at the back of > > the unit that colour.. > > > > Can someone please help lol. > > > > > > > Community email addresses: Post message: [email protected] Unsubscribe: [EMAIL PROTECTED] List Owner: [EMAIL PROTECTED] Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/gsr_evo/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
