@Björn and @Gábor Thanks a lot. It did work fine.
Now as the next step I assume, I have to add a new package. I can see from there are lot many packages listed in the https://www.gnu.org/software/guix/packages/ in alphabetic order. So should I find a new package and add it? If it is to add a new package, I see the Anaconda Package missing there. And may be I could add that in the format mentioned in 4.1 defining package , is that correct? Or should I proceed with creating video tutorials for the steps I did until now ? Thanks, Lakshmi Prasannakumar Bangalore On Thu, Oct 18, 2018 at 5:22 PM Gábor Boskovits <boskov...@gmail.com> wrote: > Hello Lakshmi, > > Björn Höfling <bjoern.hoefl...@bjoernhoefling.de> ezt írta (időpont: > 2018. okt. 18., Cs, 13:46): > > > > Hi Lakshmi, > > > > On Thu, 18 Oct 2018 14:52:30 +0530 > > Lakshmi Prasannakumar <lakshmiprasannakuma...@gmail.com> wrote: > > > > > Hi Gábor, > > > > > > I have followed the Binary-Installation procedures and installed the > > > hello package to my root. > > > The next step I understand is to add another package from the list in > > > https://www.gnu.org/software/guix/packages/ > > > I tried following this step to install a package from the list i.e. > > > 4ti2 1.6.7 using the below commands: > > > *guix package -i 4ti2 1.6.7* > > > > > > However, I got the error as : > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > *guile: warning: failed to install localehint: Consider installing the > > > `glibc-utf8-locales' or `glibc-locales' package anddefining > > > `GUIX_LOCPATH', along these lines: guix package -i > > > glibc-utf8-locales export > > > GUIX_LOCPATH="$HOME/.guix-profile/lib/locale"See the "Application > > > Setup" section in the manual, for more info.* Is it due my incomplete > > > GUIX installation or are there further steps to follow? > > > > It is safe to ignore these warnings for now. If it causes any problem, > we can return to that, > but unfortunalety sometimes this is hard to debug on foreign distros. > You could try following > the instuctions in the warning, but it does not help then just ignore > them for now. > > > > > I think there is no error. As it says, this is only a warning. Or is > > there anything else I have overseen in your message? > > > > If unsure, you can check the return code of the previous command by > > directly typing > > > > echo $? > > > > The return code should be 0. > > > > You can also list the installed packages in Guix and see if hello and > > 4ti2 are installed: > > > > guix package -I > > > > Note the CAPITAL I, > > > > You can also list the generations. As you first installed hello and in > > a second step you installed 4ti2, there should be at least two > > generations: > > > > guix package --list-generations > > > > The warning is about the locale. To get rid of it, do exactly what the > > warning says, and/or read the section of the manual that the warning is > > pointing to :-) > > > > https://www.gnu.org/software/guix/manual/en/guix.html#Application-Setup > > > > Hope this helps, otherwise feel free to ask, > > > > Björn > > Best regards, > g_bor >
