I just held the reset button in for ten seconds, and the system didn't revert to its factory settings.
----- Original Message ----- From: "Barbara J. Wagreich" <[EMAIL PROTECTED]> To: [email protected] Date: 2008/07/12 15:24:39 Subject: Re: Re: [GWN] Braille Sente plus: Periodic braille display problem in web browser > > > Hi Mike: > > Regarding the rest button on the BSP (Braille Sense Plus) restoring/not > restory factory-set defaults: I've noticed that if I press the reset > button on the BSP quickly, the current settings in the options section are > retained. However if I press the reset button a bit longer it does > restore the factory-set defaults. I don't know why this happens, but I > would prefer the factory-set defaults not to be restored! > > Barb > > > On Sat, 12 Jul 2008, Mike Keithley wrote: > > > Thank you for the reply. > > > > When this began happening, I checked many settings in the option dialog > > that I thought might cause this problem. I didn't find anything unusual. I > > normally have the display of control characters turned on, but turning this > > off didn't make a difference. I'm also using the original reading mode, and > > trying compressed mode didn't change anything. > > > > However, I did uncover an interesting fact. I remembered an old sequence I > > used to use on the Braille Sense classic to do a cold reset. This still > > works on the Plus. When I did the cold-reset and restored my settings, the > > problem went away. So I guess the bottom-line is that if it comes back, do > > a cold reset. Perhaps pressing the reset button when a website won't load > > leaves the browser in a strange state. > > > > Also, in reading the troubleshooting section in the help facility, I > > noticed it says that the system resets to factory settings after pressing > > the reset button. As I've had to do this a few time, I know this isn't > > true--the settings I had been using haven't changed. > > > > > > > > ----- Original Message ----- > > From: "Raul A. Gallegos" <[EMAIL PROTECTED]> > > To: [email protected] > > Date: 2008/07/11 19:20:55 > > Subject: Re: [GWN] Braille Sente plus: Periodic braille display problem in > > web browser > > > >> > >> > >> Hello. I went to the acb.org web site and found the page you mentioned > >> in this post. I do not see the control-l character. Did you change any > >> of the default settings, and did you have any specific settings you may > >> not have mentioned here? I am not able to reproduce the problem you > >> describe with either a Braille Sense Plus or a Voice Sense with Sync > >> Braille. > >> > >> Many thanks. > >> > >> Mike Keithley said the following on 7/10/2008 11:10 AM: > >>> Hello list, > >>> > >>> I've been having a problem reading text in the Braille Sense plus web > >>> browser where a $l control character shows at the beginning of the line, > >>> and the system will not scroll forward from that line unless I push a > >>> routing button to the right of the $l. > >>> > >>> For example, I'm on the acb.org site and I'm reading the officers and > >>> board members page. I get stuck at this line: > >>> > >>> $l Pasadena, CA > >>> > >>> If I press a routing button over a character to the right of the $l, the > >>> $l (on the left of the display) goes away and I can scroll a little more > >>> until I see another line beginning with $l. At this point I cannot scroll > >>> further until I again press a routing button to the right of the $l. > >>> > >>> If I do chord-g and listen to speech, the system scrolls along as > >>> expected. > >>> > >>> Also, there are no problems when moving the braille display through > >>> links--it just seems to involve reading text. > >>> > >>> Unfortunately I don't know if this is a consistent problem since I'm not > >>> using the browser enough. But I've not seen this behavior in any other > >>> application except the web browser. I've done warm resets, but the > >>> problem persists. I don't know how to do a hard reset on the Braille > >>> Sense plus. > >> > >> > >> -- > >> Raul A. Gallegos -- GW Micro Technical Support > >> Voice: 260-489-3671 -- Fax: 260-489-2608 > >> WEB: http://www.gwmicro.com > > > >
