On Fri, Oct 31, 2008 at 2:26 PM, Joerg Reisenweber <[EMAIL PROTECTED]>wrote:
> Sorry for any faults or ambiguities! Once again: > > change R4303 (oh-three) [0R, MIC4301:2 to GND] to 2k2 > > R4304 (oh-four) is not in the published schem [any more], it's obviously > been > replaced in schematics by C4306 [NC, MIC4301:1 to GND]. However you may > find > R4304 in component placement diagram (you won't find C4306 there!). It's > the > two empty pads left side of the component array left to mic. Symmetric to > R4303. > > > If you want to retrofit C4306 with a huge capacitor, you could use the > empty > pads of R4304 to connect it. You also *have* to make the R4303 0->2k2 > change, > otherwise mic signal is shorted by this capacitor and you won't see decent > signal on mixer input. > > HTH > cheers > jOERG > That's better. For now I stayed with the 1uF. I might change back to 100uF on Monday. While I had the phone open I took a better picture of the bead hack. http://handheldshell.com/DSCN0392.JPG http://handheldshell.com/DSCN0392_small.JPG -- Angus Ainslie http://www.handheldshell.com/
_______________________________________________ hardware mailing list [email protected] http://lists.openmoko.org/mailman/listinfo/hardware
