If your modem will go into bridge mode, and most do, and if your ISP
supports it, you can set the Zoom to bridge, and put something like a WRT54G
behind it. I've done this sucessfully, but it's not for the meek at heart :)
Then see if your server appears on the list.
Oh, BTW, please post your IP address and server name so we can look at your
server.
----- Original Message -----
From: "Brian" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Tuesday, August 09, 2005 6:58 PM
Subject: Re: [hlds] Server isn't being shown on master list?
Could be a problem with the router itself, although I would think that I
wouldn't be able to have people connect at all if this was the case.
It's not exactly something I can change though, the modem and router are
combined, a Zoom ADSL X5.. Other then this I haven't had a single
problem with it, and it seems no matter what I set it to, it doesn't
work. I may be able to test this with my old router and modem.. but I
honestly don't expect any different results.
OoksServer wrote:
Have you tried it with a different modem/router? A few years ago I had
some
adventures in cheap low-end router hell, and one thing I found was that
some
routers had some serious issues, such as Belkin for example. Cisco tested
the best, Linksys was second. Most others had various issues, such as
Netgear has a very small routing table and firmware that tends to reset
the
router on a regular basis, early Linksys firmware was ...well, shite for
the
most part but current firmware is pretty good. Dlink and Belkin were on
the
bottom of the crap router list. Nothing I did made my server appear on
the
list while using a Belkin router. Replaced the Belkin with a Netgear,
poof,
server is on the list! I have to use a Actiontek modem because of my ISP,
but I put it in gateway mode and use the Linksys to handle the PPPOE and
that pretty much eliminates the Actiontek (which is a cheap piece of junk
modem/router) from causing problems. If you happen to have WRT54G laying
around, and if you can put your modem in gateway mode, you might try
that.
<snip>
_______________________________________________
To unsubscribe, edit your list preferences, or view the list archives, please
visit:
http://list.valvesoftware.com/mailman/listinfo/hlds
