I spoke too soon... Deleting the databases and running htdig works fine (of course)
Running rundig.sh with 'mv' change to 'cp' as indicated in my previous message also works fine. However, running rundig.sh again causes the excerpts to get lost. I know that if I could just spend a little more time analyzing exactly what each switch does for htdig and htmerge, I could work it out, but I'm just not sure exactly when to run htdig -a -i and when not to. Ted On 8/30/02 3:26 PM, "Jim Cole" <[EMAIL PROTECTED]> wrote: > Ted Stresen-Reuter's bits of Fri, 30 Aug 2002 translated to: > >> Well, to figure this out, I just ran some tests. >> >> 1) Deleted all databases from the db directory >> 2) Ran htdig -c /var/htdig/conf/hci.conf >> >> Everything worked as expected. All excerpts appeared as required. >> >> 3) Ran rudig.sh >> >> Excerpts vanished. >> >> Here is the htdig and htmerge sections of rundig.sh >> >> ##### Dig phase >> STARTTIME=`date` >> echo Start time: $STARTTIME >> echo rundig: Start time: $STARTTIME > $REPORT >> $BASEDIR/bin/htdig $verbose -s -a -c $BASEDIR/conf/$CONF >> $REPORT > > Is $BASEDIR set to /var/htdig and $CONF to hci.conf? In other > words, are you sure that both approaches are using the same > config file? > > Jim > ------------------------------------------------------- This sf.net email is sponsored by: OSDN - Tired of that same old cell phone? Get a new here for FREE! https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390 _______________________________________________ htdig-general mailing list <[EMAIL PROTECTED]> To unsubscribe, send a message to <[EMAIL PROTECTED]> with a subject of unsubscribe FAQ: http://htdig.sourceforge.net/FAQ.html
