I am trying to figure out if this is expected or if I can make a change so that the post 2014 version of Hugin works like the pre-2014 version when doing lens correction.
In the old version as you would place control points they would only appear on one side of the image (left side for the left image and right side for the right images) as seen here in this screenshot - https://www.screencast.com/t/HSWzBkoPB In the post 2014 new version of Hugin you get these lines that go across the entire image on both sides as seen here - https://www.screencast.com/t/RVRV1srhI2 Whenever I put all the control points down I am able to optimize and get a set of lens correction numbers but they are always way off and still don't fully correct the image. If the UI is just different and not part of my issue, can someone help me understand where I'm going wrong when creating the lens distortion control points? I follow the steps here http://hugin.sourceforge.net/tutorials/calibration/en.shtml as well as this video here https://vimeo.com/51999287 and I can arrive at the numbers assigned to a, b, and c, but they are always way off. -- A list of frequently asked questions is available at: http://wiki.panotools.org/Hugin_FAQ --- You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/hugin-ptx/b8f52b17-fdf1-4c05-bf66-a7c76d45273b%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
