i've got the same problem on the 'enter' button on my QY-700.
it won't register on some strokes and sometimes it registers twice. that's a
major pain in the ass coz when you are in the job functions, you know what
happens when you press enter to go into a certain job function and before
you're done with the tweaking you want to do, the damn thing just execute the
job for you!!
[EMAIL PROTECTED] wrote:
It's an amazing thing, and probably just fluke. But I initially bought my RM1X
from floor stock only because it was going to be weeks before the store had
new ones, I got a good deal..and I was told that it had only hit the sales
floor recently so not a lot of time spent in use.
I returned it 2 days later because I noticed the casing was
buckled...irrelevant bable thus for i know..but I have a point, amongst other
side-effects (what I assumed to be) of a fall it must have taken chicklet # 9
wasn't working too well. That is, you had to press it hard to get a
response.....and god forbid you try to press\depress the thing quickly.
So I waited, and got a brand new one. Everything working fine...happy camper,
say no more.
Two days ago I switch on the Rm1x, start recording again after a few week
absense, and notice the exact same thing about button 9...it's annoying.
Unless you press it hard you've a 50\50 chance of the pattern change taking
effect. A potential disaster if using the machine live where timing is
invariably going to be a factor.
So here's the thing, just as a matter of interest. Are you all finding that
it's key#9, or just a different key. Because there could be a pattern, excuse
the pun.
____________________________________________________________________
Get free email and a permanent address at http://www.netaddress.com/?N=1
