I put $trace statements carefully in my ASM source. It took me about 4 days to do the 7 exits we use. It went much faster after I installed the CBT exit loader (exit 5)
Dave Gibney [EMAIL PROTECTED] System Programmer (509) 335-7359 Information Technology Washington State University Pullman, WA 99164-1222 > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[EMAIL PROTECTED] On > Behalf Of Dave Kopischke > Sent: Friday, October 13, 2006 11:17 AM > To: [email protected] > Subject: Re: Jes2 Exit52 Again > > On Fri, 13 Oct 2006 10:00:14 -0700, Gibney, Dave <[EMAIL PROTECTED]> wrote: > > > Check out SHARE Presentations from Skip Robinson and Tom Wasik > > > > I went through Skips SHARE presentation and made some changes to ignore > what comes in R1 and base all addresses off of XPL fields. Still S0C4's. > > How does everyone go about debugging these exits ??? I finally got a trace > to work, but for EXIT52 all I get is register contents before and after. > No clues as to what might be causing the S0C4. Not much to go on for a > JES2/Assembler newbie. > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO > Search the archives at http://bama.ua.edu/archives/ibm-main.html ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
