Russell,
Thank you for your response. I think I understand now and can proceed.
I was pointed to CA-1 as the problem by the following from Innovation:
There probably was a previous message that looked like this:
IEC999I IFG055CA,job,step,error-text (This message was in fact present in
the joblog.)
I believe that IFG055CA is CA's version of the EOV exit most likely with
CA-1. I would recommend calling CA with the above info as well and look at
CA-APARs QO72318 and QO73756.
end of Innovation response.
Because we are running r5.2 which I believe is not supported, I did not open an
issue with CA but chose to install the current release.
Regards,
Dave O'Brien
________________________________
From: Russell Witt [mailto:[EMAIL PROTECTED]
Sent: Tue 6/12/2007 7:55 AM
To: [email protected]
Subject: Re: CA-1 install - user exits?
Dave,
Lastly, regarding your z/OS 1.7 problems. Normally I have the highest regard
for the folks at Innovation, and am very interested in this intermittant
0C4. Do you have a dump, and have you open'ed a helpdesk issue? I know of no
outstanding 0C4 abends within the product at this time. For z/OS 1.7, at
CA-1 r11.5 you only need QO73756 to be applied. This does correct a 0C4, but
only if using our TMSTPNIT to initialize a tape. No other requirements to
CA-1 r11.5 are known to support either z/OS 1.7 or z/OS 1.8. Are the 0C4
abends in TMSTPNIT?
If you haven't yet open'ed a helpdesk issue for the intermittant 0C4, please
do so. Especially if you have some dump to look at (which I assume you do,
or the folks at Innovation wouldn't be pointing fingers).
Russell Witt
CA-1 Level-2 Support Manager
-----Original Message-----
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
