I thought that I had this figured out, but I don't...On Sunday morning Operations had done a POR (Power On Reset) to load a new configuration (SYS1.IODF00). The new configuration deleted old (no longer existing) devices and switched the 3174 console controllers to ESCON direct (without a converter). In the clean up as I was deleting old disks, I missed the fact that the esoteric called VIO was deleted because the disk associated with it were gone. To try and fix the problem I added VIO, but for some reason, I can't dynamically activate the new configuration. When I display the active configuration it says to both Hardware / Software changes allowed: the word No. Does anyone know how I can get around this problem?
Help will be appreciated... George Rodriguez :-) Specialist, Systems Programmer IT-Operations (561) 357-7652 (office) (561) 707-3496 (mobil) School District of Palm Beach County 3348 Forest Hill Blvd. Room B332 West Palm Beach, FL. 33406-5869 Rated "A" by the Florida Department of Education 2005, 2006 & 2007 ----------------------------------------- Under Florida law, e-mail addresses are public records. If you do not want your e-mail address released in response to a public records request, do not send electronic mail to this entity. Instead, contact this office by phone or in writing. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
