Wild guess:
Did you perform POR from SE ?
Did you check "allow dynamic changes" checkbox ?
--
Radoslaw Skorupka
Lodz, Poland
Schwarz, Barry A wrote:
A POR cannot load an IODF. Did you mean IOCDS?
If you changed to a new IOCDS, did someone make sure that there was a
LOADxx member in SYS1.IPLPARM that pointed to the corresponding IODF
(the one used to build the IOCDS)?
Did someone change the load parameter in the activation profile so that
the correct LOADxx member of SYS1.IPLPARM was the one actually used
during the IPL.
-----Original Message-----
From: George Rodriguez [mailto:snip]
Sent: Tuesday, June 03, 2008 4:54 AM
To: [email protected]
Subject: HCD v1.4
I thought that I had this figured out, but I don't...On Sunday morning
Operations had done a POR (Power On Reset) to load a new configuration
(SYS1.IODF00). The new configuration deleted old (no longer existing)
devices and switched the 3174 console controllers to ESCON direct
(without a converter). In the clean up as I was deleting old disks, I
missed the fact that the esoteric called VIO was deleted because the
disk associated with it were gone. To try and fix the problem I added
VIO, but for some reason, I can't dynamically activate the new
configuration. When I display the active configuration it says to both
Hardware / Software changes allowed: the word No. Does anyone know how I
can get around this problem?
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
--
BRE Bank SA
ul. Senatorska 18
00-950 Warszawa
www.brebank.pl
Sd Rejonowy dla m. st. Warszawy
XII Wydzia Gospodarczy Krajowego Rejestru Sdowego,
nr rejestru przedsibiorców KRS 0000025237
NIP: 526-021-50-88
Wedug stanu na dzie 01.01.2008 r. kapita zakadowy BRE Banku SA wynosi
118.642.672 zote i zosta w caoci wpacony.
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
