Hi Barry, Yes, I meant IOCDS. Yes, SYS1.IPLPARM(LOAD00) was changed to: IODF 00 SYS1 09
And yes, someone changed the activation profile to point to the correct LOAD00 member... Thanks, George Rodriguez Specialist, Systems Programmer IT-Operations (561) 357-7652 (office) (561) 707-3496 (mobil) School District of Palm Beach County 3348 Forest Hill Blvd. Room B332 West Palm Beach, FL. 33406-5869 Rated "A" by the Florida Department of Education 2005, 2006 & 2007 -----Original Message----- From: IBM Mainframe Discussion List [mailto:[EMAIL PROTECTED] On Behalf Of Schwarz, Barry A Sent: Tuesday, June 03, 2008 2:55 PM To: [email protected] Subject: Re: HCD v1.4 A POR cannot load an IODF. Did you mean IOCDS? If you changed to a new IOCDS, did someone make sure that there was a LOADxx member in SYS1.IPLPARM that pointed to the corresponding IODF (the one used to build the IOCDS)? Did someone change the load parameter in the activation profile so that the correct LOADxx member of SYS1.IPLPARM was the one actually used during the IPL. -----Original Message----- From: George Rodriguez [mailto:snip] Sent: Tuesday, June 03, 2008 4:54 AM To: [email protected] Subject: HCD v1.4 I thought that I had this figured out, but I don't...On Sunday morning Operations had done a POR (Power On Reset) to load a new configuration (SYS1.IODF00). The new configuration deleted old (no longer existing) devices and switched the 3174 console controllers to ESCON direct (without a converter). In the clean up as I was deleting old disks, I missed the fact that the esoteric called VIO was deleted because the disk associated with it were gone. To try and fix the problem I added VIO, but for some reason, I can't dynamically activate the new configuration. When I display the active configuration it says to both Hardware / Software changes allowed: the word No. Does anyone know how I can get around this problem? ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html ----------------------------------------- Under Florida law, e-mail addresses are public records. If you do not want your e-mail address released in response to a public records request, do not send electronic mail to this entity. Instead, contact this office by phone or in writing. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
