Did you mark the tape full? To mark any partial ML2 and backup tapes full using the 'DELVOL volser MIGRATION(MARKFULL)' or 'DELVOL volser BACKUP(MARKFULL)' commands, as appropriate. Followed by a RECYCLE
Should show tape in the state you want. Lizette > -----Original Message----- > From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf > Of Mark Pace > Sent: Friday, June 29, 2012 6:43 AM > To: [email protected] > Subject: HSM tape > > I'm trying to figure out why I have tapes that have no valid data, but still show full. > > ML1060 3590-1 ML2 0098302500 0000000000 000 * EMPTY* NO *NONE* > *NONE* 001 *** *NONE* LIB001 TPSG > ML1078 3590-1 ML2 0003932100 0000000000 000 * FULL *NO > *NONE* *NONE* 001 *** *NONE* LIB001 TPSG > > > If I run RECYCLE ML2 EXECUTE PERCENTVALID(0) it will show > ARC0830I RECYCLE COMMAND PROCESSING STARTING ARC1007I COMMAND REQUEST > 00000578 SENT TO DFSMSHSM > *** > > ARC0831I RECYCLE COMMAND PROCESSING ENDING > *** > > > But I run another TTOC and the volume that was FULL still shows FULL. > Is there another way to force HSM to mark this volume as empty? > > > -- > The postings on this site are my own and don't necessarily represent Mainline's > positions or opinions > > Mark D Pace > Senior Systems Engineer > Mainline Information Systems > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, send email to > [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
