Thanks Allan, We will give that shot... appreciate your help... -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Staller, Allan Sent: Monday, March 31, 2014 9:43 AM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: Error 878-10
In that case, I suspect there is an installation exit that converts region=0m requests to something smaller. Retry with a explicitly coded region of (based on the error message) of 32M or 64M. Al Staller | Z Systems Programmer | KBM Group | (Tel) 972 664-3565 | allan.stal...@kbmg.com -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Robert McElroy Sent: Monday, March 31, 2014 8:40 AM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: Error 878-10 Allan, IDCAMS... -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Staller, Allan Sent: Monday, March 31, 2014 9:38 AM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: Error 878-10 According to the message posted, the storage request was (unconditionally) for X'007C7318' bytes of storage in SP00 above the line (via GETMAIN or STORAGE OBTAIN). Obviously, this was not available. What utility are you attempting to use for the copy? <snip> IEA995I SYMPTOM DUMP OUTPUT 849 SYSTEM COMPLETION CODE=878 REASON CODE=00000010 TIME=08.09.00 SEQ=10871 CPU=0040 ASID=0057 IEA705I ERROR DURING GETMAIN SYS CODE = 878-10 CHRMZCBK STEP1 STEPA 00 IEA705I 00FBF400 00AFF048 00AFF048 00005200 007C7318 PSW AT TIME OF ERROR 070C1000 815A669E ILC 2 INTC 0D NO ACTIVE MODULE FOUND NAME=UNKNOWN ....irrelevant information snipped Post the IEC message describing the error. Better yet, post the job (minus the dump, if any). Anything without that information is just guessing Hoping someone can help us out with this. Getting a getmain error 878-10 in a job this is trying to do a tape-to tape copy. In looking up the error code for 878-10 one of the issues is region size is too small. The Job is coded both on the job card & the steps with REGION=0M... Any direction would be appreciated.. </snip> ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN