Staller, Allan wrote:
According to the message posted, the storage request was (unconditionally) for
X'007C7318' bytes of storage in SP00 above the line (via GETMAIN or STORAGE
OBTAIN).
Obviously, this was not available.
The request is for virtual storage below the line (X'10') that can be backed by
real storage above or below the line (X'40'). As it's about an 8-megabyte
request, it's not really surprising that it's not available. The usual
suggestion is to split the work into smaller units.
What utility are you attempting to use for the copy?
<snip>
IEA995I SYMPTOM DUMP OUTPUT 849
SYSTEM COMPLETION CODE=878 REASON CODE=00000010
TIME=08.09.00 SEQ=10871 CPU=0040 ASID=0057
IEA705I ERROR DURING GETMAIN SYS CODE = 878-10 CHRMZCBK STEP1 STEPA 00
IEA705I 00FBF400 00AFF048 00AFF048 00005200 007C7318
PSW AT TIME OF ERROR 070C1000 815A669E ILC 2 INTC 0D
NO ACTIVE MODULE FOUND
NAME=UNKNOWN
....irrelevant information snipped
Post the IEC message describing the error. Better yet, post the job (minus the
dump, if any).
Anything without that information is just guessing
Hoping someone can help us out with this. Getting a getmain error 878-10 in a job
this is trying to do a tape-to tape copy. In looking up the error code for 878-10
one of the issues is region size is too small. The Job is coded both on the job
card & the steps with REGION=0M... Any direction would be appreciated..
</snip>
Bob
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
