That should have been PUTLINE works fine.
-----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of Barry Merrill Sent: Tuesday, July 08, 2014 8:23 AM To: [email protected] Subject: Re: Authorizing 8 char technical userid to use TSO CONSOLE command Not sure if this applies to this issue, but I recall that TSO commands that issue TPUT will simply stop the rest of the commands in a Batch TSO job, but commands using PUTLOG work fine. Barry Herbert W. “Barry” Merrill, PhD President-Programmer MXG Software Merrill Consultants 10717 Cromwell Drive Dallas, TX 75229 [email protected] http://www.mxg.com - FAQ has Most Answers [email protected] – invoices/PO/Payment [email protected] – technical tel: 214 351 1966 - expect slow reply, use email fax: 214 350 3694 – prefer email, still works -----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of Peter Hunkeler Sent: Tuesday, July 08, 2014 8:16 AM To: [email protected] Subject: Aw: Re: Authorizing 8 char technical userid to use TSO CONSOLE command > Before any TSO commands may be entered, the LOGON command must be used with a > valid TSO User ID. This is not true if you run TSO in batch (EXEC PGM=IKJEFT01, etc.). You can definitely run TSO commands under an 8 char userid, although you cannot *logon* to TSO. I do understand that a userid cannot have more than 7 chars to be a "valid" TSO userid, either by defining it in the UADS or by assigning it a TSO segment. I'd like to understand what inhibits the usage of some commands whereas most commands run without problems with 8 char userids. -- Peter Hunkeler ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
