If this is a physical tape, and you can "hand it" to the operator, you might try label=(2,nl),expdt=98000 and give it a dummy volume serial number.
Thanks Bill Bishop Consultant, Mainframe Engineer Mainframe and Scheduling | Infrastructure Technology Services Toyota Motor North America [email protected] Office: (469) 292-5149 Cell: (502) 316-4386 -----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of Tom Conley Sent: Thursday, December 20, 2018 1:50 PM To: [email protected] Subject: Re: Dancing around RMM On 12/20/2018 2:36 PM, Jesse 1 Robinson wrote: > By way of update, after studying everyone's suggestions, I ran the job with > this DD: > > //TAPEIN DD UNIT=(TAPECR,,DEFER), > // LABEL=(EXPDT=98000), > // VOL=SER=(nnnnnn), > // DISP=(OLD,KEEP) > > and got pretty much the same result: > > IEF403I TAPEANAL - STARTED - TIME=14.37.42 IEC501A M uuuu, > nnnnnn,BLP,,TAPEANAL,FATAR EDG4020I VOLUME nnnnnn REJECTED BY > INSTALLATION REJECT DEFINITIONS EDG4006E VOLUME nnnnnn ON uuuu > REJECTED FOR USE BY TAPEANAL, FATAR, TAPEIN, OPEN REQUEST FAILED BY DFSMSrmm > IEC502E R uuuu,, ,,TAPEANAL,FATAR > IEC145I 413-08,IFG0194K,TAPEANAL,FATAR,TAPEIN,uuuu,, 015 > SYS18353.T143742.RA000.TAPEANAL.R0161338 > IEA995I SYMPTOM DUMP OUTPUT 016 > SYSTEM COMPLETION CODE=413 REASON CODE=00000008 CV volume STATUS(MASTER) or STATUS(USER). RMM will not allow a scratch tape to be read under any circumstances. I lost this argument with Mike Wood. Apparently no one ever had to verify the label on a scratch tape... Regards, Tom Conley ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
