By setting:
$TPRT7,FORMS=*
I am now getting my print into the NPF queue.
I was just too close to it to see it.
Thanks,
Tony Thigpen
Elardus Engelbrecht wrote on 5/30/19 11:34 AM:
Dana Mitchell wrote:
Tony Thigpen wrote:
Maybe you have a 'better way' to use NPF. Could you give me an example of what
you are doing?
So JES2 never selects output for that printer? You don't ever get $HASP150 ?
If that is the case, turn on the debug statement for JES2, something like $T
DEBUG,SECURITY=Y
I believe there are also other DEBUG statements, but you can also have a look
in your HASPARM member for your JES2 to check out the output classes.
What I do is all output for network printers goes to Class C. Different
destination for each different remote printer such as OPSPRT, SYSPRT, XRXPRT.
Different forms use different Options member.
My printer is defined like this:
PRT3 CLASS=C,
MODE=FSS,
FSS=TCPFSS,
FCB=STD8,
CKPTPAGE=100,
START=YES,
WS=(W,R,Q,PRM,LIM/F,UCS,FCB,P),
ROUTECDE=(*PRT)
To Tony Thigpen after checking Dana's definitions for JES2:
I see your CLASS=R match your SDSF screenprint, but I don't see any definition
of your FORM=TONY (as seen from your SDSF).
After you started that printer, I see FORMS=(WL1,,,,,,,),
Is that correct?
Is your WS=(Q,R/) correct? Perhaps the Work Selection is too restricted for
your printer.
I am not sure about the other criterias including that ROUTECDE...
DISCLAIMER: I never worked with NPF printers, but with other types where
connected to JES2 and other printing subsystems.
Good luck!
Groete / Greetings
Elardus Engelbrecht
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
