Well, I've got a smoking gun. https://www.ibm.com/support/knowledgecenter/en/SSLTBW_2.3.0/com.ibm.zos.v2r3 .ieam900/iea3m9_IGW_messages.htm says of messages such as IGW01557W:
For messages with the prefix IGW01, the type codes indicate the severity of the detected error and are: E Error: Return code 8 I Information: Return code 0 S Severe: Return code 16 T Ending: Return code 12 W Attention: Return code 4 Would someone who is able to do so be willing to PMR this? We're Dallas customers and thus red-headed stepchildren when it comes to IBM support. Charles -----Original Message----- From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of Peter Relson Sent: Saturday, March 7, 2020 5:46 AM To: [email protected] Subject: Re: Two related alias entry address questions >did you have an ENTRY BAR statement in the assembly? I did not. I used the form you and Gil showed of "BAR" on the "END" with no entry statement (either in the assembly or the bind). <snip> Grrr... But I've even complained of seeing a "I" suffix on messages reporting JCL errors fatal from the programmer's point of view. The rationale is that it's "Informative" from the operator's point of view. </snip> Perhaps you have forgotten what message suffixes mean for messages that are not things such as utility/compilation outputs. "W" is not warning, it is wait state. "E" is not error, it is eventual action. "I" is often the only viable choice. In general if the message is documented in "system messages", this applies (I wouldn't bet that there are no exceptions). I don't argue that that was a good decision, but it has "always" been so and will not change. For IEBCOPY, its "W" would indeed be "warning". I'm with Charles that if you get a "W" message I would expect something other than RC=0, likely RC=4. So if the argument is that you asked not to replace, and it did not replace, so that's RC=0 I'm OK with that. But then the message for that case should be "I" not "W". ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
