My impression was that the CSE area was within Cyl 0 on the volume. Is
this not correct?
--
.~. Robert P. Nix Mayo Foundation
/V\ RO-OC-1-13 200 First Street SW
/( )\ 507-284-0844 Rochester, MN 55905
^^-^^ -----
"In theory, theory and practice are the same, but
in practice, theory and practice are different."
-----Original Message-----
From: The IBM z/VM Operating System [mailto:[EMAIL PROTECTED] On
Behalf Of Kris Buelens
Sent: Monday, September 18, 2006 3:43 PM
To: [email protected]
Subject: Re: Initially setting up CSE
Remove the volumes from XLINK_INCLUDE in SYSTEM CONFIG. Do not forget
to
protect the CSE area by a dummy minidisk so that you don't place other
minidisk on top of it.
Kris,
IBM Belgium, VM customer support
"Nix, Robert P." <[EMAIL PROTECTED]>
Sent by: The IBM z/VM Operating System <[email protected]>
2006-09-18 22:33
Please respond to
The IBM z/VM Operating System <[email protected]>
To
[email protected]
cc
Subject
Initially setting up CSE
I finally got all the pieces, and started working on a zVM v5.2 system
with CSE. My problem is that, when I try to turn on CSE in the SYSTEM
CONFIG, I get then get several of the following messages in the IPL:
HCPLNM2880E MAINT 0190 is not linked, CSE LINK I/O ERROR, Code 02
The description of the error implies that XLINK FORMAT needs to be run
on
the device, but how do you do that initially, without the system
running?
I seem to be caught in a "chicken and egg" type loop?.
--
.~. Robert P. Nix Mayo Foundation
/V\ RO-OC-1-13 200 First Street SW
/( )\ 507-284-0844 Rochester, MN 55905
^^-^^ -----
"In theory, theory and practice are the same, but
in practice, theory and practice are different."
