Terry, VMFPLCD is a front-end for VMFPLC2 and VMFPLCD (for reading/writing data to/from tape and disk, respectively). All the info you'll ever want to know can be found using the HELP commands: HELP VMFPLC HELP VMFPLC2 HELP VMFPLCD
For a new VMer, HELP is a Wonderful Thing. And old VMers depend on it
too... 8-)
Mark L. Wheeler
IT Infrastructure, 3M Center B224-4N-20, St Paul MN 55144
Tel: (651) 733-4355, Fax: (651) 736-7689
mlwheeler at mmm.com
--
"I have this theory that if one person can go out of their way to show
compassion then it will start a chain reaction of the same. People will
never know how far a little kindness can go." Rachel Joy Scott
"Martin, Terry R.
(CMS/CTR) (CTR)"
<[EMAIL PROTECTED] To
.hhs.gov> [email protected]
Sent by: The IBM cc
z/VM Operating
System Subject
<[EMAIL PROTECTED] VMFPLC Command
ARK.EDU>
11/22/2008 12:19
PM
Please respond to
The IBM z/VM
Operating System
<[EMAIL PROTECTED]
ARK.EDU>
Hi
I am installing a BMC product and in the instructions it says to run VMFPLC
command to load the files from the install tape. The documentation is a
little lacking what is this command and what disk might it be on? They it
is a VM command being new with VM I have not used this command so I am not
sure about it.
Thanks,
Terry
