Varying the CHPID off, then on is supposed to reset it. But check your
FE device (111F), it is the device that is used to load the OAT.
On 01/25/2010 05:54 PM, Billy Bingham wrote:
I'm not able to load an OAT because I can't vary it online. Is there a
hardware command to re-set the device to the original OAT? Should I
just have only devices 0 & 1 defined in the IOCDS?
This is what I have defined now:
CNTLUNIT CUNUMBR=1100,PATH=(34),UNIT=OSA
IODEVICE ADDRESS=(1100,16),CUNUMBR=(1100),UNIT=OSA
IODEVICE ADDRESS=(111F),UNITADD=FE,CUNUMBR=(1100),UNIT=OSAD
Billy
On 25 Jan 2010 at 17:31, Rich Smrcina wrote:
> On 01/25/2010 05:19 PM, Billy Bingham wrote:
> >
> >
> > Hello all,
> >
> > Trying to IPL VM/ESA 2.4 on an old MP2000. The box IPLs OK, but when
> > tring to vary the OSA online I get the HCPCPN6283I... message. I do a
> > QUERY on the device and VM shows it as an OSA, but it's offline. Any
> > ideas?
> >
> >
> > Thanks,
> >
> > Billy
> Did you load an OAT into the OSA? This OSA card typically requires an
> OSA Address Table to be coded up and loaded into it before an operating
> system can use it. It will have a pair of default devices (0 & 1), but
> if your operating system isn't using the default devices...
>
> --
> Rich Smrcina
> Phone: 414-491-6001
> http://www.linkedin.com/in/richsmrcina
>
> Catch the WAVV! http://www.wavv.org
> WAVV 2010 - Apr 9-13, 2010 Covington, KY
>
--
Rich Smrcina
Phone: 414-491-6001
http://www.linkedin.com/in/richsmrcina
Catch the WAVV! http://www.wavv.org
WAVV 2010 - Apr 9-13, 2010 Covington, KY
