George,

   I have my "DEF VSWITCH" for both layer 1 and layer 2, followed by
grants, and lastly the autolog of TCPIP in my AUTOLOG1. I have not had
any issues with my switches or TCPIP with this arrangement.

                              Bob

 

From: The IBM z/VM Operating System [mailto:[email protected]] On
Behalf Of George Henke/NYLIC
Sent: Monday, November 01, 2010 3:18 PM
To: [email protected]
Subject: Re: No IPL VSWITCH Connectivity

 


I just noticed that in my AUTOLOG1 PROFILE EXEC, TCPIP is XAUTOLOGed
just before the GRANTS. 

Could it be that VSWITCH is not ready until TCPIP is fully logged on,
the TCPIP stack built? 

Do I need a delay in my AUTLOG1 PROFILE EXEC after the XAUTOLOG of TCPIP
to make this happen? 

'CP XAUTOLOG TCPIP'                           
'CP SET VSWITCH LNXVSW1 GRANT VLINUX1'         
'CP SET VSWITCH LNXVSW1 GRANT VLINUX2'         
'CP SET VSWITCH LNXVSW1 GRANT VLINUX3'         
'CP SET VSWITCH LNXVSW1 GRANT VLINUX4'         
'CP SET VSWITCH LNXVSW1 GRANT VLINUX5'         
'CP SLEEP 10 SEC'                             
'CP XAUTOLOG VLINUX1'                         
'CP XAUTOLOG VLINUX2'                         
'CP XAUTOLOG VLINUX3'                           





Mark Pace <[email protected]> 
Sent by: The IBM z/VM Operating System <[email protected]> 

11/01/2010 03:13 PM 

Please respond to
The IBM z/VM Operating System <[email protected]>

To

[email protected] 

cc

        
Subject

Re: No IPL VSWITCH Connectivity

 

                




The 2 entries I have in my system config.  1 for layer 2 and 1 for layer
3.  Both work at IPL. 

DEFINE VSWITCH VSWTCH1 RDEV 0600 CONTR * ETH 
Define VSWITCH VSWTCH3 RDEV 0604 CONTR * IP 


On Mon, Nov 1, 2010 at 3:07 PM, George Henke/NYLIC
<[email protected]> wrote: 

After IPL we can destroy the VSWITCH: 

det vswitch lnxvsw1 

Then issue the same commands as in the IPL below and everything
connects. 

Why? 

Are there some restrictions, considerations, for defining the VSWITCH at
IPL time? 

SYSTEM CONFIG: 

define vswitch lnxvsw1 portname lnxvsw1 rdev 9004 


AUTOLOG1: PROFILE EXEC: 

'CP SET VSWITCH LNXVSW1 GRANT VLINUX1'         
'CP SET VSWITCH LNXVSW1 GRANT VLINUX2'         
'CP SET VSWITCH LNXVSW1 GRANT VLINUX3'         
'CP SET VSWITCH LNXVSW1 GRANT VLINUX4'         
'CP SET VSWITCH LNXVSW1 GRANT VLINUX5'         
'CP SLEEP 10 SEC'                               
'CP XAUTOLOG VLINUX1'                           
'CP XAUTOLOG VLINUX2'                           
'CP XAUTOLOG VLINUX3'                           



-- 
Mark D Pace  
Senior Systems Engineer  
Mainline Information Systems  





Reply via email to