Well I have found 6mm Okoume at a local lumber mill for $86/sheet. I would have to cut two bulkhead pieces and epoxy them together with weights on a flat surface. Or just finish all sides on both pieces and bolt together. Sounds kinda chump, huh. What do you think of that? Maybe I'll just keep looking.
--- In [email protected], jwambo8...@... wrote: > > I replaced my starboard bulkhead with teak plywood. Cetol matched the > factory finish almost perfectly. > > John Wamboldt > C27 #6287 > ZuZu's Petals > Lake Michigan > > > In a message dated 2/8/2010 10:12:05 A.M. Central Standard Time, > dj2...@... writes: > > > > > Sunday in 36 degrees I removed the port bulkhead. Lots of rot. While my > search continues for a suitable replacement here in TN I would like the > groups > opinion about what finish to use. I assume I will use epoxy to seal the > edges but would like to match, somewhat the other finish that the factory > used. I thought about Cetol but don't yet no if the replacement ply will be > teak. The port bulkhead by the way is about 26" wide X 42"tall. > Doug > #5053 > > > > > > [Non-text portions of this message have been removed] >
