Add the agpart kernel module from Intel's site. Recompile it , make the
agpart device and insmod it. This will allocate the memory for the graphics
engine.
Get the X server from Intel's site or get the Redhat 6.2 XSVGA server . The
XSVGA server is a better Idea - since it will allow you to use XF86Setup
Or else - go to Shanu's page on the 810 - or at personal.vsnl.com/shanu
Shanker
----- Original Message -----
From: "ABHIJIT BHATTACHARYYA" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, May 05, 2000 12:19 PM
> Hi,
>
> I have recently upgraded my PC to Pentium III with INTEL 810 chipset
> motherboard. I have opted for onboard graphics accelerator. Windows98
> loaded fine and display resolution has been set to 1024 x 768 in true
> color 24 bit in SVGA mode. Then in other partition of HDD (10.2GB) [ 8 GB
> for LINUX ] I loaded Red Hat Linux 6.1. However, RH6.1 X server was not
> configured ok. It showed resolution of simple VGA16 (640X480) instead of
> SVGA(1024X768) which I need very much. I could not find a suitable card
> from the list and hence I could not configure out the XF86Setup.
>
> Can anyone help me to solve my problem so that I can use it with HiRes?
> Abhi
>
> ***************************************************************
> * ABHIJIT BHATTACHARYYA * e-mail : [EMAIL PROTECTED] *
> * [ Research Fellow ] * [EMAIL PROTECTED] *
> * C/O. Dr. A. M. Basu * PHONE : 0091-033-549-9840 *
> * Department of Physics * [RES] *
> * Jadavpur University * Flat-GG. Lolita Apartment [B]*
> * Calcutta 700 032 * 22 Narayantala (W). Cal- 59 *
> * West Bengal * INDIA *
> * India * *
> ***************************************************************
>
>
>
>
> --
> To unsubscribe, send mail to [EMAIL PROTECTED] with the body
> "unsubscribe ilug-cal" and an empty subject line.
> FAQ: http://www.ilug-cal.org/help/faq_list.html
>
--
To unsubscribe, send mail to [EMAIL PROTECTED] with the body
"unsubscribe ilug-cal" and an empty subject line.
FAQ: http://www.ilug-cal.org/help/faq_list.html
