That works...only problem is depending on how the message is originated, the FROM address may look like [EMAIL PROTECTED] It's ok internally, but can lead to a few external people seeing it as well...which can be problematic. That's why I suggested just let everyone POP the Exchange instead of trying to jury-rig or find a workaround for Exchange's peculiarities.
Darin. ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, November 30, 2004 5:56 PM Subject: RE: [IMail Forum] OT: Mail Config Issue What we did was to use a non existent domain for the exchange server. Say our external domain is domain.com the exchange domain was setup to be popforward.domain.com. The imail server has aliases setup for each exchange user to forward to the exchange servers domain. When an exchange user sends mail to someone at domain.com it is sent via smtp to the imail server. We built a connector on the exchange server for domain.com to allow this to happen. Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Darin Cox Sent: Tuesday, November 30, 2004 4:43 PM To: [EMAIL PROTECTED] Subject: Re: [IMail Forum] OT: Mail Config Issue Best bet is to pass it all to Exchange and let all users POP it from there. Exchange 2000 was almost impossible to get it to forward email to an outside POP3 server for user addresses it knew about. Exchange 2003 may be better about that, but having everyone POP the Exchange server is still the best bet. Darin. ----- Original Message ----- From: "Jim Comerford" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, November 30, 2004 12:37 PM Subject: [IMail Forum] OT: Mail Config Issue This is slightly off-topic, but this is the best list I know for mail issues. We host a web site and mail for this client They want to start using an internal Exchange Server and pass most of the mail via Exchange Pop3 connector. They have a few external users who for some reason MUST continue using pop3 This works fine on incoming mail. If Exchange user however sends mail to an POP3 user on the same domain the problem begins. I'm not an Exchange person, so these answers may be simple, but I was unable to find my answers...I have these questions: Is there a way in exchange to tell it that certain users of that domain are not internal and they need to be sent back to our server? Or if Exchange Server allows some users to connect via POP3 and get their mail, I could route all of their mail to Exchange and let those few users access it via POP3 from Exchange? Thanks for any direction here... -Jim To Unsubscribe: http://www.ipswitch.com/support/mailing-lists.html List Archive: http://www.mail-archive.com/imail_forum%40list.ipswitch.com/ Knowledge Base/FAQ: http://www.ipswitch.com/support/IMail/ To Unsubscribe: http://www.ipswitch.com/support/mailing-lists.html List Archive: http://www.mail-archive.com/imail_forum%40list.ipswitch.com/ Knowledge Base/FAQ: http://www.ipswitch.com/support/IMail/ To Unsubscribe: http://www.ipswitch.com/support/mailing-lists.html List Archive: http://www.mail-archive.com/imail_forum%40list.ipswitch.com/ Knowledge Base/FAQ: http://www.ipswitch.com/support/IMail/ To Unsubscribe: http://www.ipswitch.com/support/mailing-lists.html List Archive: http://www.mail-archive.com/imail_forum%40list.ipswitch.com/ Knowledge Base/FAQ: http://www.ipswitch.com/support/IMail/
