SLPC (Single Loop Power Controller) is a replacement for some host-based
power management features. The SLPC implementation runs in firmware on GuC.
This series has been tested with SKL and APL GuC firmware v9 (not released
yet). Current GuC firmware's SLPC interfaces are updated in v9.
The graphics power management features in SLPC in this version are called
GTPERF, BALANCER, and DCC.
GTPERF is a combination of DFPS (Dynamic FPS) and Turbo. DFPS adjusts
requested graphics frequency to maintain target framerate. Turbo adjusts
requested graphics frequency to maintain target GT busyness; this includes
an adaptive boost turbo method.
BALANCER adjusts balance between power budgets for IA and GT in power
limited scenarios.
DCC (Duty Cycle Control) adjusts requested graphics frequency and stalls
guc-scheduler to maintain actual graphics frequency in efficient range.
This patch series activates only GTPERF Turbo in GuC SLPC.
v2: Addressed review comments on v1. Removed patch to enable SLPC by
default.
v3: Addressed WARNING in igt@drv_module_reload_basic flagged by trybot BAT.
Added change for sanitizing GT PM during reset. Added separate patch
for sysfs interface to know HW requested frequency. Also, earlier
patches did not go as series hence were not correctly picked up by BAT.
v4: Changes to multiple patches. CI BAT is passing. Performance run on SKL
GT2 done and shows perf at parity with Host Turbo. For BXT, SLPC
improves performance when GuC is enabled compared to Host Turbo.
This series keeps only support of 9.18 firmware for better readability.
If needed, other SLPC interfaces for different GuC version will be
added later.
v5: This series incorporates feedback from code reviews on earlier series and
adds following new changes:
1. More changes for separation of RPS and RC6 handling for Gen9.
2. Tied up SLPC enabling with GuC load/GuC submission sequence.
3. SLPC structures are defined explicitly for event input/output.
4. Definition of SLPC parameter control and task control functions
agnostic to the underlying param definitions as they might
change with GuC versions and prepared helpers for common tasks.
5. Transition of i915 overrides done through host to guc events
to shared data and single reset event.
6. Handling SLPC status post reset through shared memory.
7. Derived helpers for setting frequency limits.
8. Removed sysfs interface to know RPNSWREQ as it is available in
debugfs interface i915_frequency_info.
9. Simple igt test to verify SLPC configuration by i915 in various
driver scenarios is prepared.
VIZ-6773, VIZ-6889, VIZ-6890
Cc: Chris Wilson <ch...@chris-wilson.co.uk>
Cc: Daniel Vetter <daniel.vet...@intel.com>
Cc: Beuchat, Marc <marc.beuc...@intel.com>
Cc: Jeff McGee <jeff.mc...@intel.com>
Sagar Arun Kamble (3):
drm/i915/gen9: Separate RPS and RC6 handling
drm/i915/slpc: Only enable GTPERF task, Disable other tasks/parameters
drm/i915/slpc: Preserve min/max frequency softlimits on re-activation
Tom O'Rourke (19):
drm/i915/slpc: Expose GuC functions for use with SLPC
drm/i915/slpc: Add has_slpc capability flag
drm/i915/slpc: Add enable_slpc module parameter
drm/i915/slpc: Sanitize GuC version
drm/i915/slpc: Use intel_slpc_* functions if supported
drm/i915/slpc: Enable SLPC in GuC if supported
drm/i915/slpc: If using SLPC, do not set frequency
drm/i915/slpc: Allocate/Release/Initialize SLPC shared data
drm/i915/slpc: Update debugfs interfaces for frequency parameters
drm/i915/slpc: Add slpc communication interfaces
drm/i915/slpc: Send reset event and handle SLPC enabling
drm/i915/slpc: Send shutdown event
drm/i915/slpc: Add parameter unset/set/get functions
drm/i915/slpc: Add support for min/max frequency control
drm/i915/slpc: Add enable/disable controls for slpc tasks
drm/i915/slpc: Add i915_slpc_info to debugfs
drm/i915/slpc: Add SKL SLPC Support
drm/i915/slpc: Add Broxton SLPC support
drm/i915/slpc: Enable SLPC, where supported
drivers/gpu/drm/i915/Makefile | 3 +-
drivers/gpu/drm/i915/i915_debugfs.c | 382 ++++++++++++++++++-
drivers/gpu/drm/i915/i915_drv.c | 17 +-
drivers/gpu/drm/i915/i915_drv.h | 4 +
drivers/gpu/drm/i915/i915_gem.c | 8 +
drivers/gpu/drm/i915/i915_guc_submission.c | 25 +-
drivers/gpu/drm/i915/i915_params.c | 6 +
drivers/gpu/drm/i915/i915_params.h | 1 +
drivers/gpu/drm/i915/i915_pci.c | 3 +
drivers/gpu/drm/i915/i915_sysfs.c | 36 +-
drivers/gpu/drm/i915/intel_guc.h | 5 +
drivers/gpu/drm/i915/intel_guc_loader.c | 45 ++-
drivers/gpu/drm/i915/intel_pm.c | 106 +++++-
drivers/gpu/drm/i915/intel_slpc.c | 586 +++++++++++++++++++++++++++++
drivers/gpu/drm/i915/intel_slpc.h | 252 +++++++++++++
15 files changed, 1440 insertions(+), 39 deletions(-)
create mode 100644 drivers/gpu/drm/i915/intel_slpc.c
create mode 100644 drivers/gpu/drm/i915/intel_slpc.h
--
1.9.1
_______________________________________________
Intel-gfx mailing list
Intel-gfx@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
