On Apr 24, 2006, at 12:35 PM, Chip Old wrote:
We recently upgraded our Barracuda 400 to firmware v3.4.01.003,
then to v3.4.01.004. Both seem to break InterMapper's Barracuda
HTTP probe. InterMapper shows the Barracuda as down and shows "Gave
up connecting to port 8000 after 0 seconds" as the reason. I'm not
sure where the "0 seconds" comes from. The timeout in InterMapper
for the device was the 3 second default, but I've tried bumping it
up to very high values. That doesn't help.
The message "Gave up connecting to port 8000 after 0 seconds"
indicates that InterMapper immediately failed when connecting to port
8000, perhaps because there isn't anything listening on that port.
This isn't a timeout issue.
TCP port 8000 is the default for the unencrypted Barracuda probe.
Have you tried using the SSL/HTTPS version of the probe? It connects
to port 443 by default.
Regards,
Bill Fisher
Dartware, LLC
____________________________________________________________________
List archives:
http://www.mail-archive.com/intermapper-talk%40list.dartware.com/
To unsubscribe: send email to: [EMAIL PROTECTED]
