I have got USB adapter to connect board to PC using OTG cable. I also tried with debugging on and off. I have three new pieces and on every I can freely rotate trimport. Can you tell me should I see any message in dmesg after connect board to PC using simple USB cable?
W dniu wtorek, 4 listopada 2014 09:33:02 UTC+1 użytkownik Ytai napisał: > > I don't understand how you can physically connect a IOIO v1 to an OTG > cable or to a PC. It was certainly not designed for that use case. This is > why the IOIO-OTG (v2) was developed. > Also, if the trimmer turns freely it is broken. You should still be able > to find the maximum clockwise point before it would drop the charging > indicator from Android. > Sounds to me like you maybe doing something wrong as far as connections > go. Your 2.3.7 device should work fine as long as you enable USB debugging. > > On Tue Nov 04 2014 at 12:04:08 AM Marek Maślanka <[email protected] > <javascript:>> wrote: > >> Thanks for reply. >> When I connect board to my phone through OTG cable then I getting charge >> indicator. >> The trimport on board doesn't have any constraint and I can infinite >> rotate to any direction. When I connect board to my PC and when I rotating >> trimport then red led changing sensitivity. So when the red led is on max >> light then it should have maximum power, I'm right? I tested it on my very >> old phone GT540 Android 2.3.7 CM7. Later I'll try test on tablet based on >> RK3066 and Android 4.1.1. >> I have one more question. When I connect board to my linux PC then I >> should get any message on dmesg? Right now there's no any new message in >> dmesg after connect. >> >> Thanks >> >> W dniu wtorek, 4 listopada 2014 05:47:00 UTC+1 użytkownik Ytai napisał: >>> >>> The blinking of the yellow light only happens upon first successful >>> connection after boot. >>> Are you getting charge indicator on the Android upon connecting? Is the >>> trim-pot fully clockwise? >>> What version of Android is this? >>> >>> On Mon Nov 03 2014 at 8:31:49 PM Marek Maślanka <[email protected]> >>> wrote: >>> >> Hi, >>>> I have new IOIO v1.0 board. AFAIK after connect IOIO to any device >>>> using USB cable status (yellow) LED should blink, but my board only switch >>>> red led on after connect to device. Any ideas? >>>> >>>> Thanks >>>> >>>> -- >>>> You received this message because you are subscribed to the Google >>>> Groups "ioio-users" group. >>>> >>> To unsubscribe from this group and stop receiving emails from it, send >>>> an email to [email protected]. >>>> To post to this group, send email to [email protected]. >>> >>> >>>> Visit this group at http://groups.google.com/group/ioio-users. >>>> For more options, visit https://groups.google.com/d/optout. >>>> >>> -- >> You received this message because you are subscribed to the Google Groups >> "ioio-users" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to [email protected] <javascript:>. >> To post to this group, send email to [email protected] >> <javascript:>. >> Visit this group at http://groups.google.com/group/ioio-users. >> For more options, visit https://groups.google.com/d/optout. >> > -- You received this message because you are subscribed to the Google Groups "ioio-users" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at http://groups.google.com/group/ioio-users. For more options, visit https://groups.google.com/d/optout.
