Hello, After working to setup my new Hauppauge PVR 150, someone in the #ivtv-dev channel and I came to realize that tuner #50 works. This is the information for the tuner from dmesg:
ivtv: ====================== NEXT CARD ====================== ivtv1: Autodetected WinTV PVR 150 card (cx23416 based) ACPI: PCI Interrupt Link [LNK1] enabled at IRQ 5 ACPI: PCI Interrupt 0000:01:0a.0[A] -> Link [LNK1] -> GSI 5 (level, low) -> IRQ 5 ivtv1: Unreasonably low latency timer, setting to 64 (was 32) tveeprom: ivtv version tveeprom: Hauppauge: model = 26132, rev = F0B2, serial# = 9328195 tveeprom: tuner = <unknown> (idx = 112, type = 4) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio processor = CX25841 (type = 23) tveeprom: decoder processor = CX25841 (type = 1c) ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] cx25840 2-0044: ivtv driver cx25840 2-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #1) cx25840 2-0044: loaded v4l-cx25840.fw firmware (14264 bytes) ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44] wm8775 2-001b: ivtv driver wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #1) ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b] ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv1: Encoder revision: 0x02050032 ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner: type set to 50 (TCL 2002N) by ivtv i2c driver #1 ivtv1: Initialized WinTV PVR 150, card #1 ivtv: ==================== END INIT IVTV ==================== I set the tuner to this as this is what my other PVR 150 uses. I checked every channel between 1 and 35 and also from 60 to 70 (for the channels which I subscribe, not 3 of them which I do not). Everything seems to work well and I hope this information can help you with updating the drivers. (I'm not even sure if this is helpful but I figured I'd send it anyway) Thanks, James _______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
