I just upgraded my mythtv machine to FC5, and ivtv-0.6.1 using atrpms.
Almost everything is fine, only ivtv-fb shows me two vertical yellow lines (my guess is sync), and if I start X in it, everything is shifted to the right. Between the lines it stays black (so, this must be the Hsync).
When playing a movie, everything is fine, except that the picture is shifted 1/3 to the right.
How can I shift the picture 1/3 of the screen to the left?
I am in PAL land (Netherlands); the card is a PVR350.
My configuration:
from lspci:
02:09.0 Multimedia video controller: Internext Compression Inc iTVC15 MPEG-2 Encoder (rev 01)
from fbset:
[EMAIL PROTECTED] ivtv-0.6.1]# fbset
mode "720x576-74"
# D: 41.475 MHz, H: 44.693 kHz, V: 74.488 Hz
geometry 720 576 720 576 32
timings 24111 88 32 16 4 88 4
rgba 8/0,8/8,8/16,8/24
endmode
From ivtvfbctl:
[EMAIL PROTECTED] ivtv-0.6.1]# ivtvfbctl -d /dev/fb0
Framebuffer state:
Framebuffer state: ON
Global alpha: ENABLED
Local alpha: disabled
Flicker reduction: ENABLED
Global alpha value: 208
Active buffer:
Offset: 0x00000000
Maximum offset: 0x00195000
Horizontal stride: 720 32-bit words
Vertical lines: 576 lines
Coordinates (x, y): 0, 0
Framebuffer state:
Framebuffer state: ON
Global alpha: ENABLED
Local alpha: disabled
Flicker reduction: ENABLED
Global alpha value: 208
Active buffer:
Offset: 0x00000000
Maximum offset: 0x00195000
Horizontal stride: 720 32-bit words
Vertical lines: 576 lines
Coordinates (x, y): 0, 0
From /var/log/messages:
Apr 4 21:31:44 jeltz kernel: ivtv0-osd: Framebuffer module loaded (attached to ivtv card id 0)
Apr 4 21:31:44 jeltz kernel: ivtv0-osd: screen coords: [0 0] -> [720 576]
Apr 4 21:31:45 jeltz kernel: ivtv0-osd: original global alpha = 208
Apr 4 21:31:45 jeltz kernel: ivtv0-osd: current OSD state = 39
Apr 4 21:31:45 jeltz kernel: ivtv0-osd: new global alpha = 208 (1 255 0)
Apr 4 21:31:45 jeltz kernel: ivtv0-osd: framebuffer at 0xf1510000, mapped to 0xdd790000, size 1665k
Apr 4 21:31:45 jeltz kernel: ivtv0-osd: mode is 720x576x32, linelength=2880
Apr 4 21:31:45 jeltz kernel: ivtv0-osd warning: ivtvfb_set_par
Apr 4 21:31:45 jeltz kernel: Console: switching to colour frame buffer device 90x36
Apr 4 21:31:45 jeltz kernel: ivtv0-osd: fb0: cx23415 TV out frame buffer device
Apr 4 21:31:45 jeltz kernel: ivtv0: Allocate DMA decoder OSD stream: 16 x 65536 buffers (1024KB total)
Thanks,
Sietse
_______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
