> Hello,
>
> I have a ivtv-driven card, and the drivers say it's unknown. Here are
> the details:
Interesting, an Avermedia card. Can you give me:
1) The card model.
2) A list of the chips that are on the board.
3) Which tuner is used on the board.
Note that it may take some time to get this working depending on what sort
of chips are on the board.
Regards,
Hans
>
>
> lspci:
>
> 0000:00:09.0 Multimedia video controller: Internext Compression Inc
> iTVC16 (CX23416) MPEG-2 Encoder (rev 01)
> Subsystem: Avermedia Technologies Inc: Unknown device c03f
> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
> ParErr- Stepping- SERR- FastB2B-
> Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
> <TAbort- <MAbort- >SERR- <PERR-
> Latency: 64 (32000ns min, 2000ns max), Cache Line Size: 0x08 (32
> bytes)
> Interrupt: pin A routed to IRQ 153
> Region 0: Memory at f0000000 (32-bit, prefetchable) [size=64M]
> Capabilities: [44] Power Management version 2
> Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
> PME(D0-,D1-,D2-,D3hot-,D3cold-)
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
>
>
> dmesg:
>
> ivtv: ==================== START INIT IVTV ====================
> ivtv: version 0.6.3 (tagged release) loading
> ivtv: Linux version: 2.6.16.20-pluto-1-686 686 gcc-3.3
> ivtv: In case of problems please include the debug info between
> ivtv: the START INIT IVTV and END INIT IVTV lines, along with
> ivtv: any module options, when mailing the ivtv-users mailinglist.
> ivtv0: Unknown card: vendor/device: 4444/0016
> ivtv0: subsystem vendor/device: 1461/c03f
> ivtv0: cx23416 based
> ivtv0: Defaulting to Hauppauge WinTV PVR-150 card
> ivtv0: Please mail the vendor/device and subsystem vendor/device IDs and
> what kind of
> ivtv0: card you have to the ivtv-devel mailinglist (www.ivtvdriver.org)
> ivtv0: Prefix your subject line with [UNKNOWN CARD].
> cx25840 1-0044: cx25841-23 found @ 0x88 (ivtv i2c driver #0)
> cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 bytes)
> tveeprom 1-0050: Huh, no eeprom present (err=-121)?
> tveeprom 1-0050: Encountered bad packet header [01]. Corrupt or not a
> Hauppauge eeprom.
> ivtv0: No tuner detected, default to NTSC
> ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
> ivtv0: Encoder revision: 0x02050032
> ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB
> total)
> ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
> ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
> ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB
> total)
> ivtv0: i2c hardware 0x00000020 not found for command 0x40345622!
> ivtv0: Initialized Hauppauge WinTV PVR-150, card #0
> ivtv: ==================== END INIT IVTV ====================
>
>
> _______________________________________________
> ivtv-devel mailing list
> [email protected]
> http://ivtvdriver.org/mailman/listinfo/ivtv-devel
>
_______________________________________________
ivtv-devel mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-devel
