Please disregard the above message.  I goofed...

I am having a big problem getting FC5 and my pvr350 to
output to my tv display.  I also could not get the rpm
from atrpms to work (It would give me a fatal error
when I modprobed ivtv)  So I built the driver from the
source (svn).  I am still having problems though.

I do not have any entries in my modprobe.conf.  I have
added the correct ones according to Jarod's guide and
then tried it without.  The card loads up without a
problem and I then modprobe ivtv-fb, but cannot
display a picture.  I did manage recently to get two
orange vertical lines on my tv towards the left side. 
However I have not been able to reproduce that either.
 here is a copy of the appropiate sections.

dmesg:
ivtv:  ==================== START INIT IVTV
====================
ivtv:  version 0.6.2 (development revision 3251)
loading
ivtv:  Linux version: 2.6.16-1.2096_FC5smp SMP 686
REGPARM 4KSTACKS gcc-4.1
ivtv:  In case of problems please include the debug
info between
ivtv:  the START INIT IVTV and END INIT IVTV lines,
along with
ivtv:  any module options, when mailing the ivtv-users
mailinglist.
ivtv0: Autodetected Hauppauge WinTV PVR-350 card
(cx23415 based)
ACPI: PCI Interrupt 0000:02:01.0[A] -> GSI 17 (level,
low) -> IRQ 20
ivtv0: Unreasonably low latency timer, setting to 64
(was 32)
tveeprom 1-0050: The eeprom says no radio is present,
but the tuner type
tveeprom 1-0050: indicates otherwise. I will assume
that radio is present.
tveeprom 1-0050: Hauppauge model 48132, rev K268,
serial# 8207888
tveeprom 1-0050: tuner model is LG TAPE H001F MK3 (idx
68, type 47)
tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08)
tveeprom 1-0050: audio processor is MSP4448 (idx 27)
tveeprom 1-0050: decoder processor is SAA7115 (idx 19)
tveeprom 1-0050: has radio, has IR remote
tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0)
tda9887 1-0043: chip found @ 0x86 (ivtv i2c driver #0)
saa7115 1-0021: saa7115 found @ 0x42 (ivtv i2c driver
#0)
saa7127 1-0044: saa7129 found @ 0x88 (ivtv i2c driver
#0)
usb 1-1: new low speed USB device using uhci_hcd and
address 4
msp3400 1-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c
driver #0)
msp3400 1-0040: MSP4448G-A2 supports radio, mode is
autodetect and autoselect
usb 1-1: configuration #1 chosen from 1 choice
input: Logitech USB Receiver as /class/input/input0
input: USB HID v1.10 Keyboard [Logitech USB Receiver]
on usb-0000:00:1d.0-1
input: Logitech USB Receiver as /class/input/input1
input: USB HID v1.10 Mouse [Logitech USB Receiver] on
usb-0000:00:1d.0-1
usb 1-2: new full speed USB device using uhci_hcd and
address 5
ieee1394: Host added: ID:BUS[0-00:1023] 
GUID[00023c0020021a4a]
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144
bytes)
usb 1-2: configuration #1 chosen from 1 choice
hub 1-2:1.0: USB hub found
hub 1-2:1.0: 4 ports detected
ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144
bytes)
ivtv0: Encoder revision: 0x02040024
ivtv0: Decoder revision: 0x02020023
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768
buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 194 x 10800
buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 120 x 17472
buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x
4608 buffers (2048KB total)
ivtv0: Create encoder radio stream
ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536
buffers (1024KB total)
ivtv0: Allocate DMA decoder VBI stream: 512 x 2048
buffers (1024KB total)
ivtv0: Create decoder VOUT stream
ivtv0: Allocate DMA decoder YUV stream: 24 x 43200
buffers (1024KB total)
ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648
bytes)
usb 1-2.1: new low speed USB device using uhci_hcd and
address 6
tuner 1-0061: type set to 47 (LG NTSC (TAPE series))
usb 1-2.1: configuration #1 chosen from 1 choice
input: Logitech Logitech Gaming Keyboard as
/class/input/input2
input: USB HID v1.10 Keyboard [Logitech Logitech
Gaming Keyboard] on usb-0000:00:1d.0-2.1
input: Logitech Logitech Gaming Keyboard as
/class/input/input3
input,hiddev96: USB HID v1.10 Device [Logitech
Logitech Gaming Keyboard] on usb-0000:00:1d.0-2.1
ivtv0: Initialized Hauppauge WinTV PVR-350, card #0
ivtv:  ======================  NEXT CARD 
======================
ivtv1: Autodetected Hauppauge WinTV PVR-150 card
(cx23416 based)
ACPI: PCI Interrupt 0000:02:03.0[A] -> GSI 19 (level,
low) -> IRQ 18
ivtv1: Unreasonably low latency timer, setting to 64
(was 32)
tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #1)
usb 1-2.4: new full speed USB device using uhci_hcd
and address 7
saa7115 2-0021: saa7115 found @ 0x42 (ivtv i2c driver
#1)
usb 1-2.4: configuration #1 chosen from 1 choice
input: G15 Keyboard G15 Keyboard as
/class/input/input4
input,hiddev97: USB HID v1.11 Keypad [G15 Keyboard G15
Keyboard] on usb-0000:00:1d.0-2.4
msp3400 2-0040: MSP3445G-B8 found @ 0x80 (ivtv i2c
driver #1)
msp3400 2-0040: MSP3445G-B8 supports radio, mode is
autodetect and autoselect
tveeprom 2-0050: Hauppauge model 32062, rev B185,
serial# 7367115
tveeprom 2-0050: tuner model is TCL 2002N 6A (idx 85,
type 50)
tveeprom 2-0050: TV standards NTSC(M) (eeprom 0x08)
tveeprom 2-0050: audio processor is MSP3445 (idx 12)
tveeprom 2-0050: decoder processor is SAA7115 (idx 19)
tveeprom 2-0050: has no radio, has IR remote
ivtv1: Corrected autodetection from Hauppauge WinTV
PVR-150 to Hauppauge WinTV PVR-250
ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144
bytes)
ivtv1: Encoder revision: 0x02040024
ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768
buffers (4096KB total)
ivtv1: Allocate DMA encoder YUV stream: 194 x 10800
buffers (2048KB total)
ivtv1: Allocate DMA encoder VBI stream: 120 x 17472
buffers (2048KB total)
ivtv1: Allocate DMA encoder PCM audio stream: 455 x
4608 buffers (2048KB total)
tuner 2-0061: type set to 50 (TCL 2002N)
ivtv1: Initialized Hauppauge WinTV PVR-250, card #1
ivtv:  ====================  END INIT IVTV 
====================



after I modprobe ivtv-fb


Apr 25 21:05:41 mythpvr kernel: ivtv0-osd: Framebuffer
module loaded (attached to ivtv card id 0)
Apr 25 21:05:41 mythpvr kernel: ivtv0-osd: screen
coords: [0 0] -> [720 480]
Apr 25 21:05:41 mythpvr kernel: ivtv0-osd: original
global alpha = 208
Apr 25 21:05:41 mythpvr kernel: ivtv0-osd: current OSD
state = 39
Apr 25 21:05:41 mythpvr kernel: ivtv0-osd: new global
alpha = 208 (1 255 0)
Apr 25 21:05:41 mythpvr kernel: ivtv0-osd: framebuffer
at 0xf1510000, mapped to 0xe2310000, size 1665k
Apr 25 21:05:41 mythpvr kernel: ivtv0-osd: mode is
720x480x32, linelength=2880
Apr 25 21:05:41 mythpvr kernel: ivtv0-osd: fb1:
cx23415 TV out frame buffer device
Apr 25 21:05:41 mythpvr kernel: ivtv0: Allocate DMA
decoder OSD stream: 16 x 65536 buffers (1024KB total)


modprobe.conf:

alias eth0 8139too
alias snd-card-0 snd-emu10k1
options snd-card-0 index=0
options snd-emu10k1 index=0
remove snd-emu10k1 { /usr/sbin/alsactl store 0
>/dev/null 2>&1 || : ; }; /sbin/modprobe -r
--ignore-remove snd-emu10k1
alias snd-card-1 snd-mpu401
options snd-card-1 index=1
options snd-mpu401 index=1
remove snd-mpu401 { /usr/sbin/alsactl store 1
>/dev/null 2>&1 || : ; }; /sbin/modprobe -r
--ignore-remove snd-mpu401
# nvidia kernel module
alias char-major-195 nvidia-1_0-8756
alias nvidia nvidia-1_0-8756
# ivtv modules setup
#alias char-major-81 videodev
#alias char-major-81-0 ivtv
#alias char-major-81-1 ivtv
#install ivtv /sbin/modprobe --ignore-install ivtv;
/sbin/modprobe ivtv-fb

ll /dev/video*
lrwxrwxrwx 1 root   root      6 Apr 25 21:03
/dev/video -> video0
crw------- 1 mythtv root 81,  0 Apr 25 21:03
/dev/video0
crw------- 1 mythtv root 81,  1 Apr 25 21:02
/dev/video1
crw------- 1 mythtv root 81, 16 Apr 25 21:03
/dev/video16
crw------- 1 mythtv root 81, 24 Apr 25 21:03
/dev/video24
crw------- 1 mythtv root 81, 25 Apr 25 21:02
/dev/video25
crw------- 1 mythtv root 81, 32 Apr 25 21:03
/dev/video32
crw------- 1 mythtv root 81, 33 Apr 25 21:02
/dev/video33
crw------- 1 mythtv root 81, 48 Apr 25 21:03
/dev/video48


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 

_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users

Reply via email to