If i look at the end of this i see where we create /dev/fb0 - but dont see it creating /dev/fb1. Any ideas?
ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.7.1 (tagged release) loading
ivtv: Linux version: 2.6.17-1.2187_FC5 SMP mod_unload gcc-4.1
ivtv: In case of problems please include the debug info between
ivtv: the START INIT IVTV and END INIT IVTV lines, along with
ivtv: any module options, when mailing the ivtv-users mailinglist.
ivtv0: Autodetected Hauppauge WinTV PVR-350 card (cx23415 based)
ACPI: PCI Interrupt 0000:01:08.0[A] -> Link [APC3] -> GSI 18 (level, low) -> IRQ 58
ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
tveeprom 0-0050: Hauppauge model 48132, rev K268, serial# 8512288
tveeprom 0-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47)
tveeprom 0-0050: TV standards NTSC(M) (eeprom 0x08)
tveeprom 0-0050: audio processor is MSP4448 (idx 27)
tveeprom 0-0050: decoder processor is SAA7115 (idx 19)
tveeprom 0-0050: has radio, has IR remote
ohci_hcd 0000:00:0b.0: wakeup
tuner 0-0061: chip found @ 0xc2 (ivtv i2c driver #0)
tda9887 0-0043: chip found @ 0x86 (ivtv i2c driver #0)
saa7115 0-0021: saa7115 found @ 0x42 (ivtv i2c driver #0)
usb 1-1: new low speed USB device using ohci_hcd and address 2
saa7127 0-0044: saa7129 found @ 0x88 (ivtv i2c driver #0)
msp3400 0-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c driver #0)
msp3400 0-0040: MSP4448G-A2 supports radio, mode is autodetect and autoselect
usb 1-1: configuration #1 chosen from 1 choice
input: USB Optical Mouse as /class/input/input1
input: USB HID v1.11 Mouse [USB Optical Mouse] on usb-0000:00:0b.0-1
ieee1394: Host added: ID:BUS[0-00:1023] GUID[0016e60000b8dc18]
ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)
ivtv0: Encoder revision: 0x02050032
ivtv0: Decoder revision: 0x02020023
ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
ivtv0: Create encoder radio stream
ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total)
ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total)
ivtv0: Create decoder VOUT stream
ivtv0: Allocate DMA decoder YUV stream: 24 x 43200 buffers (1024KB total)
ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes)
tuner 0-0061: type set to 47 (LG NTSC (TAPE series))
ivtv0: Initialized Hauppauge WinTV PVR-350, card #0
ACPI: PCI Interrupt Link [AAZA] enabled at IRQ 22
ACPI: PCI Interrupt 0000:00:10.1[B] -> Link [AAZA] -> GSI 22 (level, low) -> IRQ 217
PCI: Setting latency timer of device 0000:00:10.1 to 64
ivtv: ====================== NEXT CARD ======================
ivtv1: Autodetected Hauppauge WinTV PVR-350 card (cx23415 based)
ACPI: PCI Interrupt Link [APC4] enabled at IRQ 19
GSI 22 sharing vector 0x42 and IRQ 22
ACPI: PCI Interrupt 0000:01:09.0[A] -> Link [APC4] -> GSI 19 (level, low) -> IRQ 66
ivtv1: Unreasonably low latency timer, setting to 64 (was 32)
tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #1)
tda9887 1-0043: chip found @ 0x86 (ivtv i2c driver #1)
saa7115 1-0021: saa7115 found @ 0x42 (ivtv i2c driver #1)
saa7127 1-0044: saa7129 found @ 0x88 (ivtv i2c driver #1)
msp3400 1-0040: MSP4448G-A2 found @ 0x80 (ivtv i2c driver #1)
msp3400 1-0040: MSP4448G-A2 supports radio, mode is autodetect and autoselect
tveeprom 1-0050: Hauppauge model 48132, rev K268, serial# 8512274
tveeprom 1-0050: tuner model is LG TAPE H001F MK3 (idx 68, type 47)
tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08)
tveeprom 1-0050: audio processor is MSP4448 (idx 27)
tveeprom 1-0050: decoder processor is SAA7115 (idx 19)
tveeprom 1-0050: has radio, has IR remote
hda_codec: Unknown model for ALC882, trying auto-probe from BIOS...
ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv1: loaded v4l-cx2341x-dec.fw firmware (262144 bytes)
ivtv1: Encoder revision: 0x02050032
ivtv1: Decoder revision: 0x02020023
ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
ivtv1: Create encoder radio stream
ivtv1: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total)
ivtv1: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total)
ivtv1: Create decoder VOUT stream
ivtv1: Allocate DMA decoder YUV stream: 24 x 43200 buffers (1024KB total)
ivtv1: loaded v4l-cx2341x-init.mpg firmware (155648 bytes)
tuner 1-0061: type set to 47 (LG NTSC (TAPE series))
ivtv1: Initialized Hauppauge WinTV PVR-350, card #1
ivtv: ==================== END INIT IVTV ====================
ivtv0-osd: Framebuffer module loaded (attached to ivtv card id 0)
ivtv0-osd: screen coords: [0 0] -> [720 480]
ivtv0-osd: original global alpha = 208
ivtv0-osd: current OSD state = 39
ivtv0-osd: new global alpha = 208 (1 255 0)
ivtv0-osd: framebuffer at 0xe1510000, mapped to 0xffffc20011690000, size 1665k
ivtv0-osd: mode is 720x480x32, linelength=2880
ivtv0-osd warning: ivtvfb_set_par
Console: switching to colour frame buffer device 90x30
ivtv0-osd: fb0: cx23415 TV out frame buffer device
ivtv0: Allocate DMA decoder OSD stream: 16 x 65536 buffers (1024KB total)
lirc_dev: IR Remote Control driver registered, at major 61
bttv: driver version 0.9.16 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________ ivtv-users mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-users
